A potential relay operates on the voltage potential created by the induced voltage in the starting winding of the motor. It is an electromagnetic switch whose coil is wired directly in to the motor circuit. When power is applied to the circuit, the motor starts . As the motor attains its running speed the start winding acts as an auto generator and the voltage potential produced energizes the relay coil which cuts out the start capacitor and the start winding . The start winding still acts as an auto generator , however , and continues to produce enough power to keep the relay energized.
The voltage for a potential relay will depend on the circuit that the relay is installed in. The relay can be made for low voltages (5v) to higher voltages (440.)
The electrical control panel for a refrigeration unit using single or three phase power. The control portion has an oil pressure safety switch, defrost timer, temperature controls and perhaps a refrigerant pressure control in conjunction with the normal internal overload circuit breakers for the compressor. After operation of the refrigeration unit for a period of time, a defrost control device cuts off the compressor and turns on the electric defrost heaters. As the evaporator coils are defrosted, defrost thermostats open the defrost heater supply circuits. When the current sensing relay senses that all the defrost heaters have been shut off via the defrost thermostats, a time delay relay will return the refrigeration unit to the normal refrigeration cycle. The same current sensing relay will prevent false triggering by the oil pressure safety switch if the compressor's internal overload circuit breaker opens
you dont waste to much energy but it still works fine.
Both Current and Potential Transformers are used for relays according to the working of relay.
A potential transformer steps the high voltage down to a level of 120 V to measure them safely and easily.
current relay are using for over current low state & high state.but potential relay are related to voltage.
An evaporator in a refrigeration system works by passing warm air over it's coils.
The voltage for a potential relay will depend on the circuit that the relay is installed in. The relay can be made for low voltages (5v) to higher voltages (440.)
Bypass the relay and if the pump works the relay is bad.
Common wire of the potential relay goes to the compressor contactor. (5) Start wire of the potential relay goes to compressor run capacitor. (2) Run wire of the potential relay goes to the start capacitor. (1)
If the pump is running the relay is good.
put in a new relay... if the window works it was a bad relay
Potential or voltage relay is used for assisting the motor to start. Its operation is based on the increase in back-electro-motive force (back-EMF).
If neither side works, the Flasher Relay is defective. Replace it.If neither side works, the Flasher Relay is defective. Replace it.
Absorption refrigeration works by using a refrigerant that is absorbed into a liquid solution, which is then heated to release the refrigerant as a gas. The key principles of absorption refrigeration include the use of heat to drive the refrigeration cycle, the absorption of the refrigerant into a liquid solution, and the release of the refrigerant as a gas through heating.
both
Whatever controls the relay must be broken, if everything beyond the relay works.