As example, at 380V the generator produces 685A per phase. Therefore you will require 2 x 120mm2 cables per phase. (1 x 120mm2 cable will support 365A per phase).
In total you will require approximately 1/2km of cable to cover the 50m run between the generator and the ATS panel/Load. i.e. 5 phases in total - 2 x 50m cables per phase.
The capacitors in a generator is to store energy produced. They are also needed when starting the generator as a considerable amount of extra power is needed at this time.
A 5 kW generator would turn it over but if the full 30 hp of mechanical power is needed, that would require about 30 kW of electric power from the generator.
A bench and no load! Whatever you are testing has no load. It might be a generator or a motor for example. If a motor it wouldn't be connected to anything. If a generator it would have nothing plugged in.
A 1-ton AC can melt a ton of ice in 24 hours. The power needed is theoretically 3517 Watts so allowing for power factor and efficiency you would need a 7 kVA generator.
probably about 50 hp depending on how reliable the efficiency ratings of the various manufacturers are
The capacitors in a generator is to store energy produced. They are also needed when starting the generator as a considerable amount of extra power is needed at this time.
The generator should be about ¾ hp.
The voltage of the generator needs to be stated to give an answer.
A hydroelectric generator does not require much maintenance. If you build it right or if you purchase a decent generator, you should not have much problems.
A wire and a magnet
10 meters of wire
not you kan not start 22kw motor with 25kva generator (οχι)
A generator for a three bedroom house would be medium sized. Try a small to medium sized generator that can be found online or at any hardware store in your neighborhood.
Well all generators with a few exceptions produce 120 volts. What will determine if a generator will run your air conditioner is the number of watts the generator will put out. You need to learn the wattage needed by the air conditioner and also learn the max watts put out by the generator you have (Assuming you have one already) it the generator produces more watts that needed by the AC unit you are good to go. Not on the other hand if the generator you have dose not produce enough watts or you do not have one then it is a matter of buying a generator with the wattage required by the AC unit in your camper. Now if you are going to buy one I would also determine what else you would like to run from the generator (in addition to the air conditioner. Figure out the watts need by these items add them together with the watts needed by the AC unit. Then buy a generator big enough for your needs.
The size of diesel generator varies greatly. The size that is needed would depend on the size of the house.
The cable that is used to connect from the generator is based on the size in kW's of the generator and the generator's breaker size rated in amps. It usually is a flexible cab-tire 4 wire cable if the generator is a portable type. If it is a stationary generator is has to be wired with a flexible conduit so as not to transmit vibration from the generator to the conduit system.
The size of the generator needed to run an oxygen generator at home depends on the power requirements of the oxygen generator. Make sure to check the power consumption of the oxygen generator in watts and choose a generator that can handle that load with some extra capacity to account for start-up surges. It's best to consult with the manufacturer of the oxygen generator for specific power requirements.