Do you mean 'battery'
A voltage buffer is a circuit that will buffer a source from an output.
When people talk about 480V systems, they mean 480 is the RMS voltage.
none voltge
Peak reverse voltage of a diode is the maximum reverse bias voltage can be applied to diode which does not cause break down.
You mean the conversion from voltage V to voltage level LV. Voltage level LV = 20 * log V 117 volts equals 41.36 dB. The reference voltage 1 volt means 0 dB.
Voltage is
The mean load voltage, in other words the average voltage, is zero in an ac system.
the device oprates on the minimum voltage. in this voltage is called threshold voltage.
That depends on what you mean. If you mean why does a circuit which has a high voltage side and a low voltage side have a greater average current on the low voltage side, it is probably because of power conservation: P = IV. If this is not what you mean, you will have to be more specific!
A voltage buffer is a circuit that will buffer a source from an output.
Voltage is not measured in ohms. It is measured in volts.
none voltge
If you put a number of candy chips in a batter, they are interspersed in the batter.
Voltage on ground can mean an open ground. It can also mean (high) current on ground, due to a ground fault such as reversed neutral and ground.
Another name for average voltage is the RMS (Root Mean Square). This is a voltage derived from the peak to peak voltage multiplied by .707. If the peak to peak voltage is 170 volts then the average voltage (RMS) would be 170 x .707 = 120 volts.
The voltage regulator on a 1986 Buick Skyhawk is located inside the alternator. It controls the amount of power sent to charge the batter based on its current state.
"voltage", "electrical potential difference", and "electric tension" -- they all mean the same thing.