the voltage and frequency are 110v and 50(or)60hz because the devices which are invented in us are work at that voltage and it is efficient for that devices.
If the load is non inductive and straight resistive then there is no problem. Inductive loads like motors, a 60 Hz device can be used on 50 Hz but it is much harder on the equipment if 50 Hz is used on a 60 Hz system.
If you can use it in your lamp it will be a 20 watt bulb
60HZ
In Europe and in northern Japan 50 hz is used. The US has a 60hz system for its' power grid.
No India uses 240V at 50Hz the U.S. uses 110V at 60Hz.
the voltage and frequency are 110v and 50(or)60hz because the devices which are invented in us are work at that voltage and it is efficient for that devices.
Depending on the device, it may or may not work. And if it works, it won't work properly. A 60Hz devices needs 60 cycle current, not 50.
No. For more information see the answers to the Related Questions shown below.
Depends. Some smaller stuff can usually run on both, in which case it will be printed on them. If it isn't, you can't run a 220v item on 110v.
You can use a frequency converter to change the output frequency of the inverter from 60Hz to 50Hz. This will allow you to use devices that are rated for 50Hz frequency with your 110V 60Hz inverter. Just make sure to select a frequency converter that is compatible with the power output of your inverter.
Yes, purchase a step-down transformer.
The commercial voltage in Taiwan is 110V. The frequency of this voltage that is supplied to homes and other places is 60Hz.
To run an 8oz 110v-60Hz popcorn machine, you would need a generator with a minimum running wattage of around 1000-1200 watts. This accounts for the initial surge of power needed to start the machine, as well as the continuous power requirement while it is operating.
NO dear we can not rotate a 110 vlolt motor on 220,but if your voltage is 110v then y can rotate it on 50hz ,no problem,but it will rotate at lower speed, ENGR. NASEER AHMED,PAKISTAN
If the load is non inductive and straight resistive then there is no problem. Inductive loads like motors, a 60 Hz device can be used on 50 Hz but it is much harder on the equipment if 50 Hz is used on a 60 Hz system.
The internal working of the motor is designed for 110V/60Hz. Your stepdown converter is from 220V/50Hz to 110V/50Hz. Frequency converters from 50Hz to 60Hz are very expensive (many times the cost of a new clipper). Therefore it is better you get a clipper designed for 220V/50Hz. If you still like to put your clipper to use, then the most cost effective solution would be to get a "car inverter" that would convert 12V DC to 110V/60Hz AC.