I will assume that your question is in reference to CT and transformer polarity.
In the case of a CT (Current Transformer) they have to be installed in the correct direction for proper metering. The polarity check is used to verify that they are installed correctly and that the polarity marks are correct (if the CT has them).
In the case of a transformer there are two types of polarity, additive and subtractive. If you are paralleling Transformers you have to ensure that they are the same type polarity in addition to other attributes.
Hope this helps.
Alternative AnswerIn a new electrical installation, a polarity test is conducted to ensure that socket outlet terminals are correctly wired (line really is line, neutral really is neutral, and the protective conductor (earth/ground) really is protective conductor. It's also important, for example, that the centre pin on an Edison Screw lampholder is connected to line, and not to neutral.
a polarity test is a test which use to check the polarity of tranformer.the rision of this test to running the two or more transformer in parallel.like bettry situation or to fin the terminals
There is a test swich which will change the polarity of the sensors........
earth fault impedance test,very important to proper operation of protection system then insulation tests in conduits insulation test of switches resistance test of cables. polarity tests in switches
Lick your own bum
A: To begin with the leads polarity of the meter must be ascertain. Assuming the red is positive voltage then that lead will have a positive potential to check a diode connect the red lead to the anode and the black to the cathode and it should read some Resistance
To my own understanding, you will use multi-meter to test for the polarity
You shouldn't need to perform a polarity test on a CT, as its terminals are normally identified with polarity markings.
To test polarity on a boiler set the meter to loop, touch the two leads together, and it will buzz or read as "000". This will show you the polarity as well as test for continuity.
a polarity test is a test which use to check the polarity of tranformer.the rision of this test to running the two or more transformer in parallel.like bettry situation or to fin the terminals
a test to be conduct for find the phase...
Knowing the polarity of transformers is important if they are to be connected in parallel.
There is a test swich which will change the polarity of the sensors........
earth continuity insulation resistance polarity
Different material welds differently depending on polarity. There are also different types of welding rods, so polarity must be tested.
the polarity of the battery is reversed
A 'polarity test', as it applies to a switch, is performed to confirm that the switch is located in the line conductor and not in the neutral conductor.
The polarity of both ends of a magnet is different. The positive and negative polarity exist for a magnet.