0
If the 2 amps is the output amperage of the power supply, the maximum that should be drawn from the unit is 2 amps. The load amperage that is connected to the power supply should govern the amperage of the fuse used. There is not much range there, the fusing could go from .25 to 2 amps.
If the input amperage is 2 amps then the input and output voltage of the power supply should be stated.
What else can I help you with?
What size wire for a 45 AMP fuse?
what size wire would be required for an ak012 with a power supply of 208/240-3-60 hz
What is the breaker size for a10kw 380v 3 phase power supply?
10amp
What fuse do you need for a 500 watt amp?
For a 500-watt amplifier, the recommended fuse size typically ranges from 30 to 50 amps, depending on the specific amp's design and the manufacturer's guidelines. It's important to consult the amplifier's manual for the exact fuse rating, as using the correct fuse helps prevent damage to the amplifier and ensures safe operation. Additionally, consider the wiring and power supply requirements when selecting the fuse.
How do you calculate the watts of a central air and heat unit?
You should not have to calculate the watts of the unit. All the information that you need will be on the nameplate of the unit. It is this information that electricians use to calculate the conductor size and breaker to supply the power to the unit.
Size fuse for 12 AWG wire?
Use a 20 amp fuse or breaker.
What size wire for a 45 AMP fuse?
what size wire would be required for an ak012 with a power supply of 208/240-3-60 hz
What size fuse goes into a 49cc moped?
The size fuse should be noted on the old fuse.
Will a 240 volt lamp work in a 110 volt supply if the supply fuse size were increased?
No. The 240V lamp will pop the circuit or fuse because the draw is higher than the supply.
What pieces of information are needed before selecting a power supply?
The main piece of information needed is the load wattage or amperage that will be connected to the power supply. Once this is known the power supply of a greater size that the load should be chosen. Also with this information the size of the wires can be calculated from the power supply to the load. Too small a wire will create a voltage drop at the load end of the circuit. This will cause under performance of the load.
What is the fuse size for a 200 watt McKinley amp?
The Full load current of that amp is approx. 17A, but you base you fuse size between the Full load current of your load and the current carrying capacity of the supply cable, if the size or the CCC of the cable is unknown, I would recommend sticking as close to the FLC as possible
What size fuse should be in the plug for a kettle?
The appropriate fuse size for a kettle is typically 13 amps. This is because most kettles have a power rating between 2000 to 3000 watts, which requires a 13 amp fuse to handle the current safely. Always check the manufacturer's specifications to ensure compliance with their recommendations. Using a fuse of the correct size helps prevent electrical hazards.
What should be the size fuse for tail and dash board fuse?
15 amp fuses
What are the specifications and size of a motherboard or power supply?
The "form factor."
Why does your computer mouse and keyboard not work anymore after changing the power supply?
Possibly not enough output power. Are you sure that you got the right size power supply?
What size fuse for cigaret lighter astra envoy 1600?
Should be a 10 amp fuse the red fuse.
What size Power window fuse does a 95 Honda civic have?
30A
What size wire should be used for a 50 amp RV plug installation?
For a 50 amp RV plug installation, a wire size of 6 AWG should be used to ensure safe and efficient power supply.
