answersLogoWhite

0

Yes. But,circuit breaker are usually rated in terms of current they can interrupt,not the voltage.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How many suspenssion type insulation used in 66kv transmission line?

one insulator unit can bare 11kV. such that 66kV tx line needs 6 insulator units.


How much must be the distance between two conductors of 11kv line?

600mm is the distance between two conductors in 11kv line


Is it possible to use an Air Circuit Breaker for protection on 11KV line instead of SF6's Circuit Breakers?

Craig, Please refer to Australian Standard AS3000:2007 for the answer.


What is the Phase to phase voltage of 66KV earthed cable?

Nominal transmission and distribution voltages are line voltages. So '66 kV' is a line-to-line voltage. Note that there is no such thing as a 'phase-to-phase' voltage -the correct term is 'line-to-line'. Using the term, 'phase-to-phase', indicates a lack of understanding of a.c., which is not uncommon! Incidentally, the symbol is 'kV', not 'KV'.


What is Indian railway transmission line voltage?

220v, 415v, 6.6 kv, 11kv,33kv,132kv,400kv


Where does the vacuum breaker install in the drain line?

A vacuum breaker is usually installed at the top of a vertically-mounted drain pipe leading to a drain. The water drainage hose from an appliance such as a dishwasher or washing machine should never be plumbed directly into a drain stand pipe without a vacuum breaker. The vacuum breaker prevents contaminated water from the drain being sucked back into the appliance if it has a fault.


Can a thermostat cause a breaker to trip?

If it is a line thermostat and it is connected across the line instead of in series with the load then yes it will trip the breaker.


Can you attach a 20 amp breaker to a 30 amp line?

yes, you can attach. but if the current through the line i.e. through the breaker exceeds 20 amp the breaker will trip. As long as the line carries 20 amp or less there is no problem.


What is the minimum height for high power lines over a road?

On 11-66kV not less than 5,5 metres,with hazard signs on both sides indicating height of line.


Why 630 amps load breaker switch is used in ht line?

A circuit breaker is necessary to protect the equipment from faults.


Do you need to use some type of mini breaker panel with a single 15A circuit breaker to connect a 15A receptacle into a 30A line?

Yes, you need to use a mini breaker panel with a 15A circuit breaker to safely connect a 15A receptacle to a 30A line. The breaker panel will protect the receptacle and wiring from the higher current capacity of the 30A line, preventing potential overheating or damage. It's important to match the amperage of the circuit breaker with the rating of the receptacle to ensure safe electrical operation.


Why would 2005 dodge ram new fuel pump be blowing fuel out around top?

Broken/miss-installed line.Broken/miss-installed line.