Yes, a clogged PVC (Positive Crankcase Ventilation) system can damage an engine. When the PVC is blocked, it can lead to increased pressure in the crankcase, causing oil leaks and potentially forcing oil into the intake system. This can result in poor engine performance, increased emissions, and in severe cases, engine damage due to oil contamination and inadequate lubrication. Regular maintenance of the PVC system is essential to prevent such issues.
PVC - Positive Crankcase Ventilation. Used to allow the engine to vent out pressure that is creates while operating. Generally it is vented back into the air intake system after the air filter to get "burned" in the combustion chamber.
PVC = polyvynlchloride
Semi-Rigid PVC
With a PVC locator
Yes.
Yes, you can do serious damage to the engine if the converter is clogged.
It could be a clogged PVC valve.
PVC valve is clogged
If the converter is partially clogged it can cause the engine to overheat which can cause serious problems. Other than that if will not harm the engine.
I would suspect something along the lines of a PVC valve that is causing oil to be in the intake. The PVC valve equalizes pressure inside the engine, otherwise as the pistons move down there would be compressed air inside the engine. The PVC valve is a check valve, it only allows air to flow one way. If it were clogged with trash and stays open then oil could get to the intake.
where is the PVC valve on a 2000 Chevrolet S-10 2.2 engine
Yes, PVC pipes can be unglued without causing damage by using a PVC pipe primer and solvent cement to soften the adhesive bond and carefully separating the pipes.
No, plumber's putty should not be used on PVC pipes. It is not compatible with PVC and can cause damage to the pipes. It is recommended to use a PVC-specific sealant or cement for PVC pipes.
how remuve and remplece pvc
Yes, hexane can damage PVC pipes by causing swelling or softening of the material. It is not recommended to use hexane with PVC pipes due to the potential for degradation and leakage. It is advisable to consult the manufacturer's guidelines for compatible solvents.
a PVC hose is a hose connected to the back of the intake manifold to the front of the engine
where is the pvc valve located on a 1980 olds cutlass 3.8 v-6