Yes. The field is provided by the shunt windings, which are connected in parallel with the supply. You may be confusing a motor with a generator, as you cannot start a shunt generatorwithout residual magnetism.
It depends on both the wiring of the motor and what if any residual magnetic field remains in the field windings. If there is some residual field, you will get some volts, but not many. If the motor has permanent magnets, it is effectively a dynamo.
It fails to build up because self excited DC motor's armature have only one direction of rotation. So that if the poles of the armature are reversed, then this causes the reduction in the residual magnetism and eventually, it will stop.
Why fan motor is not self started?
When an electric motor is started, space heating is typically managed by using a control system that monitors the motor's temperature. Once the motor reaches a certain operating temperature, the control system can deactivate the heating elements or adjust the power supplied to them. This process ensures that the motor operates efficiently without overheating, as excessive heat can lead to damage or reduced performance. Additionally, thermal protection devices may be employed to automatically cut off heating if temperatures exceed safe limits.
It is a type of starter that allows a motor to be started across the line by starting the motor with a reduced inrush current. The motor is started in a wye configuration until it gets up to speed and then a timer drops the wye contactor out a draws the delta configured contactor in. The motor then operates in a delta wired configuration.
A motor will turn when only the armature is excited, if there is enough residual magnetism in the field.
because of the residual magnetic flux that exists in the motor initially due to the poles
because of the residual magnetic flux that exists in the motor initially due to the poles
Yes it can be restored by priming the generator set using a 12 volt battery. Connect the battery in right polarity to the slip rings. The generator must be run first, as soon as the voltmeter register rising voltage disconnect the battery immediately.
You must have a permanent magnet in the field or residual magnetism that produce magnetic flux lines across the rotating conductors. Without an energized coil (electromagnet) or permanent magnet near the conductors, the motor will never be able to create electricity.
The magnetic hold in coil uses magnetism along with the electric motor that turns the drum.
It depends on both the wiring of the motor and what if any residual magnetic field remains in the field windings. If there is some residual field, you will get some volts, but not many. If the motor has permanent magnets, it is effectively a dynamo.
At no load, the flux is only due to the residual flux, which is very small. the no load speed of dc series motor is very high. so the rotating part of the motor are damaged. hince dc series motor should never be run without motor.
It fails to build up because self excited DC motor's armature have only one direction of rotation. So that if the poles of the armature are reversed, then this causes the reduction in the residual magnetism and eventually, it will stop.
Most often through induced magnetism such as an electric motor.
A motor is a mechanism that spins by means of electric energy and uses magnetism to spin. It uses energy.
Electric motor