Yes, most VFDs can run faster than the input power frequency so you can run a motor to 60Hz with a 50Hz power source. Just be aware that as speed increases, so will the current. Also be aware that a motor is rated to run a specific rpm and running faster may cause motor bearing failure after a short time.
What effect will be there on the motor (Induction) output power when a 100kW 50hz motor is connected to a 60hz power supply.
This should not be a problem but check with the manufacturer of the laundry equipment to be certain.
The motor will run, probably at nearly the same speed, but it cannot supply the same mechanical load. If it can be run on a lighter load, proportional to the voltage, it should be OK.
Yes. It will make your motor a little faster though, so it depends on what you are powering with this motor. IE Can the piece of eguipment be ran faster?
The fan will spin slower, attempt to pull more current than it would at 60 Hz, and may therefore overheat (or blow a breaker).
What effect will be there on the motor (Induction) output power when a 100kW 50hz motor is connected to a 60hz power supply.
Actually plasma screens are in total 600hz but they are divided in 10 subfields, each of which run at 60hz. But in conclusion, 10 subfields of 60hz reduce motion blur almost to zero and look alot cleaner than 1 subfield of 120hz, 240hz, etc.
This should not be a problem but check with the manufacturer of the laundry equipment to be certain.
The motor will run, probably at nearly the same speed, but it cannot supply the same mechanical load. If it can be run on a lighter load, proportional to the voltage, it should be OK.
No
This can not be answered with the information you have given. 60Hz does not relate the the current draw so wire size can not be calculated.
Yes. It will make your motor a little faster though, so it depends on what you are powering with this motor. IE Can the piece of eguipment be ran faster?
In North America, the standard is 240V, 60Hz.
The the supply stays within +/- 5% of what the motor is rated for, you can do this.
The fan will spin slower, attempt to pull more current than it would at 60 Hz, and may therefore overheat (or blow a breaker).
No, the compressor& fan will run too fast and will more than likely be damaged. It may not be damaged but I would not take a chance.
It depends on the TV; you'll have to check the specification of the TV in question.