It would not be immediately dangerous but there is a possibility of overheating with the 9% overvoltage so it isn't a good idea unless the motor is lightly loaded and watched very carefully. The safe voltage range should be marked on the motor.
If the motor is a three phase the most likely voltage the motor operates on will be 480 volts.
Depends on the motor and the load on that motor. If the motor is loaded to its capacity, it will draw the same amount of power as it would on 690 volts - which will result in ( 690/480 = ) 144% of normal current, which will thermally damage the motor, or will trip overload protection.
It depends on your definition of efficiency. 480 can certainly push more power than 208 through the same size conductors, but it would not be efficient to wire a motor for 480 when 208 was all that was needed.
220 volt single phase from 480 volt 3 phase that one wire taken one phase and second wire connected in earth point. we get 220 v The above answer is incorrect, one phase from a three phase 480 volt system will give you 277 volts to ground. You must use a transformer to get the voltage you need.
Only if you want to damage it. "277" Volt 3-phase will usually mean 277 from each phase to neutral, and 480 from phase to phase. By "230 3-phase", you likely mean 120 phase-to-neutral, and 208 phase-to-phase. If you really mean 230, then you are probably NOT talking about a three phase motor.
1.73*480*22
50 kVA is 16.667 kVA per phase and you divide that by the phase voltage. Current = 16667 / 277 = 60 Amps
If the motor is a three phase the most likely voltage the motor operates on will be 480 volts.
The systems are one in the same. Yes.
Depends on the motor and the load on that motor. If the motor is loaded to its capacity, it will draw the same amount of power as it would on 690 volts - which will result in ( 690/480 = ) 144% of normal current, which will thermally damage the motor, or will trip overload protection.
It depends on your definition of efficiency. 480 can certainly push more power than 208 through the same size conductors, but it would not be efficient to wire a motor for 480 when 208 was all that was needed.
No, it is not recommended to run a 570 volt motor on a 480 volt power supply. The motor is rated for a specific voltage to ensure optimal performance and prevent damage. Running the motor at a lower voltage could result in overheating and premature failure.
Yes, you can, and it won't burn out IF>>> the horsepower rating is the SAME. Pay attention to wiring and motor rotation. Also check the voltage: the motor voltage must be the same as the voltage between two hots of your 3 phase system. You will only use two hots as this is a single phase motor.
i have 200 hp motor what i need cable size in 100 feet distance
yes
220 volt single phase from 480 volt 3 phase that one wire taken one phase and second wire connected in earth point. we get 220 v The above answer is incorrect, one phase from a three phase 480 volt system will give you 277 volts to ground. You must use a transformer to get the voltage you need.
Only if you want to damage it. "277" Volt 3-phase will usually mean 277 from each phase to neutral, and 480 from phase to phase. By "230 3-phase", you likely mean 120 phase-to-neutral, and 208 phase-to-phase. If you really mean 230, then you are probably NOT talking about a three phase motor.