dp=Cah(1/T0-1/T1)
d
main focus on inductance calculation
The mix proportion for M40 concrete is 1:1.65:2.92W/C ratio = 0.4The design calculation is as per IS mix design
Dear Sir Kindly suggest which book i have to refer for cold storage design or could supply some calculation guide book for the same mkjain 09910484067 i think u can refer to refrigeration and air conditioning by wilbert f.stoeker
A safety factor is an aspect of design that increases strength or protection beyond that suggested as needed by calculation or other basic assessment. For example, engineering calculations might suggest a bridge needs a certain amount of strength in a support beam. That number would be increased by, perhaps, 20% as a "safety factor" in case it were to be stressed beyond its design or in case some basis for the calculation was in error.A partial safety factor is one of several safety factors applied to the same instance.
The horsepower equivalent of an engine can vary depending on its design and efficiency, but a rough estimate is that 139 cc typically translates to about 4 to 5 horsepower. This calculation is based on the general rule of thumb that 1 horsepower is roughly equivalent to 15 cc in a small engine. However, for more accurate assessments, specific engine characteristics should be considered.
Smoke moves in the chimney due to the difference in temperature and pressure between the inside and outside of the chimney. As hot air rises, it creates a draft that draws the smoke up and out of the chimney. The design of the chimney, including its height and width, can also impact how efficiently the smoke is expelled.
The degree is based on the design method and the area of operation. there is no fixed formula for its calculation
The design is in us patent under Shimon Elmaleh calculation is according to size .materiel. speed or power need to be achieved.
When planning a chimney replacement project, key factors to consider include the condition of the existing chimney, the materials to be used for the replacement, the design and size of the new chimney, compliance with building codes and regulations, and hiring a qualified contractor for the job.
d
The height of a two-story chimney typically ranges from 20 to 30 feet, depending on the height of each story and the design of the chimney. A standard story is usually about 10 to 15 feet tall, so a two-story chimney would be constructed to accommodate this height. Additionally, factors such as the chimney's location, building codes, and architectural style can influence its final height.
main focus on inductance calculation
Refer IEEE 80- 2003 For Design of grounding of 132kV substation.
The Anglo-Saxons referred to a chimney as a "smoke hole" or "smoke vent." This term reflected the design of their homes, which typically featured a central hearth with a hole in the roof to allow smoke to escape. The concept of a proper chimney, as we know it today, evolved later in history.
The horsepower of a 125cc four-wheeler typically ranges from about 7 to 15 horsepower, depending on the engine design and tuning. Smaller, more efficient engines may produce lower horsepower, while those designed for performance may reach the higher end of that range. It's important to note that actual horsepower can vary based on factors like weight, gearing, and overall vehicle design.
The 1998 Yamaha R1/YZF-R1 had 150 horsepower and a 5-valve design. When the 2007 model came out, the horsepower had been increased to 180.