No, a toilet does not require a P-trap because it has a built-in trap within its design, which helps prevent sewer gases from entering the home. The toilet's trap is specifically shaped to retain a small amount of water, creating a seal. However, additional drainage systems in the home, like sinks or bathtubs, do need P-traps.
You CAN'T have a p-trap under the toilet! The p-trap is built into the toilet!
A P trap exits horizontal from the back of the toilet and a S trap exits vertical from the bottom of the toilet.
P-trap may be cracked, nuts are loose on p-trap, or check for leak above p-trap that may be dripping down on p-trap.
Disconnect and remove p-trap from under fixture. Clean out clog in p-trap and re-install.
Sink is not vented properly and the water from the p-trap under the sink COULD be sucked out by the hydrostatic pressure from the toilet flushing.
You CAN'T have a p-trap under the toilet! The p-trap is built into the toilet!
A P trap exits horizontal from the back of the toilet and a S trap exits vertical from the bottom of the toilet.
A frost proof toilet the trap is located below the frost line
P-Traps are built into every toilet by the manufacturer
Nope
The trap is in the toilet. There shouldn't be one in the drain itself.
No.. The trap is built into the toilet. It can become clogged or obstructed with debris, but if it were to collapse, your entire toilet would be gushing water everywhere.
You need aP-trap under every sink. Get a plumber if you don't know what you are doing.
P-trap may be cracked, nuts are loose on p-trap, or check for leak above p-trap that may be dripping down on p-trap.
Disconnect and remove p-trap from under fixture. Clean out clog in p-trap and re-install.
A toilet has a built in trap thus NO othyer trap is needed and will cause air bound systems and many problems with improper drainage
Yes... is the short answer. The toilet has a trap in itself. You would have to be able to break out the floor and put a P trap in the existing line