Because they are completely unrelated things? Synchronization can be implemented with semaphores or mutexes.
- synchronization in which the decision instants is brought into alignmentwith the received bit,i.e, the basic signaling element.- it is used to generate a clock signal at the proper sampling instants. - it consists of non linear element followed by phase locked loop ( PLL ).
explain the term session in server side programming approach
A: I wouldn't call propagation delay that applies to other media. for a PC delay are parasitic in nature mostly layout. But the real and actual delay is inherited from the I/O which is the soul of PC speed. No matter how fast a PC is internally it must service those interrupts and that is really the delay actually
Project and Production are 2 totally different concepts, so I don't think it's reasonable to compare them together. The are 4 phases in the project lifecycle: * Initiating * Planning * Implementing * Closing
The 8085 Microprocessor has five interrupts signals that can be used to interrupt a program execution. They are:INTR-Interrupt Request (Input): This is used as a general -purpose interrupt.INTA-Interrupt Acknowledge (Output): This is used to acknowledge an interrupt.RST 7.5, RST 6.5, RST 5.5-Restart interrupts (Inputs): These are vectored interrupts that transfer the program controls to specify memory locations. There have higher priorities than the INTR interrupt. Among these three, the priority order is 7.5, 6.5 and 5.5.TRAP (Input): This is a non-mask able interrupt and has the highest priority.In addition to the interrupts, three pins - RESET, HOLD, and READY - accept the externally initiated signals as inputs. The HOLD signal indicates that a peripheral such as a DMA (Direct Memory Access) controller is requesting the use of the address and data buses. The READY signal is used to delay the microprocessor READ or WRITE cycles until a slow-responding peripheral is ready to send or accept data. When this signal goes low, the microprocessor waits for an integral number of clock cycles until it goes high. Lastly, when the RESET IN signal goes low, the program counter is set to zero, the buses are tri-stated, and the MPU is reset and the RESET OUT signal indicates that the MPU is being reset and used to reset other devices.To respond to the HOLD request, the 8085 Microprocessor has one signal, called HLDA (Hold Acknowledge). It acknowledges the HOLD request.
Interrupts are not sufficient in multiprocessor systems since disabling inter rupts only prevents other processes from executing on the processor in which inter rupts were disabled; there are no limitations on what processes could be executing on other processors and therefore the process disabling interrupts cannot guarantee mutually exclusive access to program state.
communication his implementing developement
Appropriate funds = Stealing
(Q)What are Hardware and software interrupt? draw the block daigram of 8259 interrupt controller and explain in brief..
total quality management
- synchronization in which the decision instants is brought into alignmentwith the received bit,i.e, the basic signaling element.- it is used to generate a clock signal at the proper sampling instants. - it consists of non linear element followed by phase locked loop ( PLL ).
Some effective strategies for implementing time outs for toddlers include setting clear rules and expectations, using a designated time out spot, remaining calm and consistent, and providing positive reinforcement for good behavior. It is important to explain the reason for the time out and to use it as a tool for teaching appropriate behavior rather than as a punishment.
define BCNF. Explain with appropriate example
Exposition is when an author interrupts a story in order to explain something, usually to provide important information.
dialog control
explain the term session in server side programming approach
No