Your reciprocating compressors have to be the booster compressors (if running on low temp system)feeding its discharge to the suction of the screw(not directly)(if running on medium temp.
An axial compressor operates by using a series of rotating and stationary blades arranged in a cylindrical configuration. As air enters the compressor, the rotating blades impart kinetic energy to the air, increasing its velocity. This high-speed air then passes through the stationary blades, which convert the kinetic energy into increased pressure by reducing the velocity. The process continues through multiple stages, resulting in significantly compressed air ready for combustion or other applications.
No, lights in a simple circuit are not dimmer than in a series circuit. This is because there is only one bulb in a simple circuit and that bulb can have the full power of the battery, while in a series circuit, the power is shared between two or more bulbs.
No, they cant take multiple paths because for one component of the circuit to operate it can bypass the other components to power that one. It does not require all components to be on(like a series circuit) for just one component to operate.
Resistors are rated in wattage so the lowest wattage rating will be the wattage of the series circuit. It will be able to handle that power any more and the lowest wattage resistor could be damaged and fail.Another AnswerWhen two or more resistors are connected in series, the resistor with the lowest resistance will operate at the highest power. If the power developed by a resistor exceeds its rated power, then the resistor may burn out.
Your description of the system is either contradictory or incomplete, therefor no answer can be given.
There are several kinds of compressors--reciprocating, screw, centrifugal. We'll use a reciprocating compressor in this example. It's got a piston moving back and forth in a cylinder to compress the air. (It's like a car engine, and you can get a kit to turn an old Volkswagen engine into a compressor.) This assembly is called a stage. The cheapest compressors are single-stage units--they have one piston and cylinder. The air from the atmosphere is sucked into the assembly, compressed then sent to the tank. Next come two-stage compressors, which have a low-pressure stage and a high-pressure stage. The air from the first stage is compressed again by the second stage, which gives more pressure with less stress on the unit. It's easier on the compressor to take air from 2 atmospheres to 4 than it is to go from 1 atmosphere to 4. A three-stage compressor takes this doubly compressed air and compresses it again, and a four-stage compressor has a fourth compression step. Most of the people who buy three-stage compressors fill diving tanks with them--you need to be able to make 5000 psi to fill a diving tank, and three-stage compressors are good for that.
The air conditioning compressor pressurizes the refrigerant sending it through a series of chambers. This compressor is normally called a centrifugal compressor.
series
A Refrigerator is technically a series because if one wire goes out all of the others go out
yes..it works
They are different.Many people think that an Ingersoll Rand 05H25NG series and the newer 20H40NG series are identical to the 15T4 air compressor from which it was derived. However, there are many major differences that have been engineered into the CNG compressors that make it quite different. Some of these differences include:Reduce lift valves with inconel springsHydrostatically tested castingsForged steel 1st - 2nd - 3rd stage connecting rodsUnique connecting rod bushingsExplosion proof LOLSLocking crankpin bushing designSpecial gasketsSpecial oil sealsUnique pressure gauge and pressure relief valve configurationOversized stainless steel interstage and control tubingUnique interstage traps suitable for electrical solenoid controlled dumping24 hour test on natural gas
A series circuit could be used to operate a string of Christmas lights. Each light bulb would be connected in a series, so that if one bulb burns out, the entire string would stop working. This setup ensures that all lights in the series receive the same amount of current.
It differs state to state.
The examples of everyday series circuits are the flashlight that uses batteries to operate. Another example is the Christmas tree lights.
The type of motor which is known as the Johnson series J0005530, is a fuel-injected motor which uses pistons to operate.
18
Nope, unfortunately on that vehicle you cannot bypass the a/c compressor pulley and run a shorter belt because it will hit the water pump...........