0
What else can I help you with?
What is the drawback of the CSMA access method?
Collisions can decrease network performance.
Disadvantage of using network-level broadcast to locate resources in a single Ethernet?
what is networking & operating system
Which port should you connect a router to a lan?
It shouldn't matter which port you use unless it involves a network switch.
What is ethernet cable?
Ethernet cable is typically 8-core category 5 (CAT5) cable with RJ45 plugs on each end, capable of bi-directional network transmission up to 100m. CAT5e and CAT6 are better quality cable for network communications over longer distances.
Can ccna have any effect on the resume of an electronics engineer?
It is the Electrical Engineers that do come up with all the networking standards like IEEE 802.11 and Ethernet. A EE with the CCNA automatically is able to have the title of Network Engineer.
What characteristic to an Ethernet network using hubs does using an Ethernet switch minimize or avoid?
Collisions
What happens when you plugin the Ethernet cable to your PC?
when ethernet cable is plugged in it is detected by ethernet card. if the cable is connected to network it detects that network and dispalys " you are connected to network"
What is the function of CSMA CA on a wireless Ethernet network?
To prevent collisions.
Which 2 might cause excessive data collisions on an ethernet network?
The overall network length exceeds IEEE 802.3 standards for that network type.A server on the network contains a faulty NIC.
Which of the two following might cause excessive data collisions on a ethernet network?
Excessive broadcasts, and using hubs instead of switches or routers to segment the network.
What are the types of Ethernet collisions?
Ethernet collisions can be classified mainly into two types: single collisions and multiple collisions. A single collision occurs when two devices try to transmit data simultaneously, resulting in a single point of failure. Multiple collisions happen when more than two devices attempt to send data at the same time, leading to a series of collisions. In both cases, the devices involved must use a backoff algorithm to retry transmission after a collision is detected.
Which network control protocol is used to prevent collisions on a full duplex network?
Full Duplex Ethernet uses no network control protocal to prevent collisions. This is because full duplex has a deicated channell for transmit and receive. When communicating in full duplex mode, there is no area to have a collision.
What symptoms would probably be present if your 100 Base TX Ethernet network length is 200 meters?
B. Excessive late collisions
What if your network is configured as a single IP subnet Multiple hubs are connected to an Ethernet backbone You need to reduce the number of collisions on the network.What should you do?
Install a switch.
What is Ethernet bridge?
An Ethernet bridge is a networking device that connects two or more network segments, allowing them to function as a single network. It operates at the data link layer (Layer 2) of the OSI model, using MAC addresses to forward data frames between segments. By filtering traffic and reducing collisions, Ethernet bridges can enhance network performance and efficiency. They are commonly used to extend the reach of a local area network (LAN).
A sentence for protocol?
Most network cards nowadays use the Ethernet protocol.Most network cards nowadays use the Ethernet protocol.Most network cards nowadays use the Ethernet protocol.Most network cards nowadays use the Ethernet protocol.
What is the first thing that happens when a collisions occurs in an Ethernet network?
When a collision occurs, the stations back off and stop transmitting. After a randomly chosen period of delay, the data is resent.
