The question you pose doesn't make a lot of sense. An RPM is a unit of rotation and an amp is unit of electrical current. You can't convert these units just willy-nilly. Now if you were wondering about the correlation of RPMs in an electrical dynamo and the current produced, that would make more sense... I'm just not sure what you're asking.
You don't. The units measure different things.
Wire Sizing Amps
To convert microamps to amps, you need to divide the value in microamps by 1,000,000. This is because one microamp is equal to one millionth of an amp. So, if you have a current of 500 μA (microamps), you would divide 500 by 1,000,000 to get 0.0005 amps.
Electrical power = current x voltage Current is in amps
You have to know the power loading and phase angle (or power factor) between each pairh of the phases, otherwise you could be making serious errors.
You cannot, the terms are incompatable.
4.3 amps
To convert VA to amps, you can use the formula Amps = VA / Volts. In this case, Amps = 140 VA / 240 V = 0.5833 Amps.
Amps is amps be it DC or AC.
voltage is measured in terms of volts ; current is measured in terms of amps.........................................
1 Amps = 1000 miliamps 0.01 Amps = X x= 0.01 X 1000 = 10 miliamps
Watts are the product of amps x volts.
You cannot in any sensible way. RPM is a measure of (angular) velocity whereas litres is a measure of volume. Your hard disk will have an rpm but what does litres mean in terms of the disk?
The electrical equivalent to torque is AMPS. Power in Electricity is Volts * Amps Where in a rotating shaft its RPM * Torque
At what voltage? When you know the voltage then, to get the amps those kilovolt-amps contain, you simply divide the kilovolt-amps by the voltage.
all you have to do is convert it..........
To convert high voltage (HV) amps to low voltage (LV) amps, you can use the formula: HV amps = LV amps x (LV voltage / HV voltage). By rearranging the formula, you can calculate LV amps by dividing HV amps by the ratio of HV voltage to LV voltage.