answersLogoWhite

0

you can smell it hydrolic oil has a distinct smell to it AnswerHydraulic fluid is almost always thinner than motor oil. Answermotor oil is slightly slick if you rub it between you're fingers. hydraulic fluid will fell the same as brake fluid when rubbed between you're fingers.

motor oil (new) will (typicly) be a darker shade as well. hydraulic fluid is normally clear or very close to clear.

note: you should not leave either of these fluid's on you're skin. you should wash hands as soon as you are done handling them.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you tell if hydraulic jack needs fluid?

Remove the fill plug and top it off with hydraulic oil.


Where is the hydraulic pump for a 1995 Chrysler le baron gtc convertable and how do you refill it?

Behind the rear seat under the well cover the motor will tell you what to get their is a rubber plug in the top of the motor that's were the fluid goes. Hope this helps.


What size hydraulic motor is needed to be equal to a 16 hp gas engine?

there is no such thing as a hydraulic motor........there is, however, a hydraulic pump. there is such thing as a hydraulic motor. the hydraulic pump will pump oil to the motor and a pressure differential across the motor causes the fluid power to be converted to mechanical power. the power output of the motor is determined by the motor's pressure, flow, displacement, and torque. ________________________________________________________________ I believe the above post is wrong in part and right in part. Choosing a hydraulic motor to replace you 16hp gas engine requires more information than just the horsepower. It would be helpful to know many other factors, such as required torque needed in the application and the rpm. When these play a part in overall horsepower, knowing these pieces of information will help find a motor. When I've purchased motors in the past, I've used this website. They are very thorough and well-priced. www.surpluscenter.com What I took away from the response above, is the person was trying to tell you how to replace a whole hydraulic system. However, its needed in your case, so long as you have a new power source for the hydraulic motor. (IE: a gas engine to power a hydraulic pump, then lines from the hydraulic pump to the hydraulic motor (insert a valve if you wish to control motor speed and/or direction), and then the hydraulic motor. Its important to have a hydraulic tank with enough capacity to hold all the fluid which will be in motion. The more devices in the system, the bigger the tank. Hope this helps!!


How can you tell if a clutch master cylinder has gone bad?

They sometimes leak hydraulic fluid down on to the carpet where the peddles are.


How can you tell the difference between a hydraulic lifter and a mechanical lifter on a Chevy 350 engine?

Take a pushrod and push down on the plunger in the lifter. A hydraulic lifter is spring loaded.


What type of hydraulic fluid is used in a 618 Grasshopper lawn mower?

The most common fluid used in those specific mowers are Dextron III. If you still have the manual, it will also tell you.


What do you do if someone accidently drained the tranny fluid instead of the oil?

Refill the transmission fluid, and never let them touch your vehicle again. Someone who can't tell the difference between an oil pan and an engine has no business wrenching on any motor vehicle, period.


How can you tell t the difference between pneumatics and hydraulic system?

hi hih hih ih i have no idea what you're talking about


What oil does a manual transmission take?

for starts its not oil. its more like hydraulic fluid. and your owners manual should tell you what weight gear oil to use.


How do you tell the difference between 1991 camaro engines?

The VIN number for the car will identify the motor.


What do you do when your poptropica character says there is no need to use the freeze fluid in wimpywonderland?

because when you have the fluid in a difference place except where the school is it will tell you that you don't need it in that certain place.


How do you tell if hydraulic cylinder is bypassing?

It will be extremely hot!