No. The temperature of the unit would be at the ambient temperature of the room.
One ton =12,000 btu's. A 5 ton unit would provide 60,000btuh of cooling. lc Refrigeration is the ability to remove heat. Like anything else distance,weight, temperature etc. there is a need to measure it. Tonnage is the unit of measure used to express refrigeration capacity.
It is a 1-1/2 ton: 18000 BTU (unit size)/12,000 BTU (per ton)=1.5
Hi: because your air handling unit is obviously containing your cooling coils which act as dehumidififiers with hot moist air. The moisture these cooling coils extracts from the air ends up collecting in these pans and should drain to a safe drainage area via drainage pipe before over filling. In fact! usually their is a safety backup drain and also a safety shut off float for unit shut down for extremely bad luck. Hope this helps ; Jimiwane
Without knowledge of the pressure in the air cond. lab. unit you will not be able to calculate the mass flow. Without the mass flow you cannot do any analysis of the system.
The difference between an air handling unit and a package unit have to do with the way air is circulated or cooled. An air handling unit recycles the air from the structure back into the system. A package unit cools the air as it enters a structure through the use of intake fans.
air handling units reserculate the treated air at required temperature at any serving area but fresh air unit did not reserculate fresh air , exhaust used air.
2
in air handling unit
2.5 or 31k btu
It is a 5 ton unit.
The operating principle of air handling unit is by circulating and then conditioning air flow. This is achieved by cooling, heating and ventilating the units.
It is a 3 ton unit.
Yes. The blower motor of an air handling unit can be considered as an ignition source.
Planned Preventative Maintenanceschedule of tasks that keep the air handling unit efficient, daily/month/yearly etc.
air handling unit
The Tempstar AC model NXA636GKA100 number is a quality air conditioning unit. The tonnage number refers to the amount or unit of cooling and the seer number is for the efficiency. This model has different unit numbers to determine the tonnage and seer numbers.