I'm going to assume you're referring to the frequency of AC (Alternating Current) and I'm going to assume that you're asking because you have some device that wants 50Hz and you are faced with a 60Hz supply. That is a lot of assumptions but you didn't give a lot of information.
It is possible but you'd have to convert the 60Hz AC to DC then back to 50Hz AC. It would involve some expensive equipment. I'm not aware of a one-box solution but you could piece together a system with an AC-DC battery charger, adequate storage batteries, and a DC-AC power inverter. Depending on your application, you might be better off replacing the equipment that won't run on 60Hz.
Before running off and spending your money on this, check the labels for your equipment. The label on my laptop power supply says it accepts 110vac-240vac at 50/60Hz. If you're going to run into problems it would most likely be with electric motors.
You don't.
ONE THING FOR SURE THERE IS NO CHANGE IN VOLTAGE IF SAME EQUIPMENT WE ARE TALKING ABOUT. THE ISSUE HERE IS THE CHANGING LOAD FREQUENCY 60HZ TO 50HZ OR VICE VERSA. FOR EXAMPLE THE MOTOR HORSEPOWER AND R.P.M. WILL BE APPROXIMATELY 90 AND 83 PERCENT OF THE NAMEPLATE SPECIFICATIONS, ALSO THE FULL LOAD RUNNING TORQUE WILL INCREASE APPROXIMATELY 8 PERCENT IF USED FROM 60HZ TO 50HZ.
You can get a transformer that converts the UK's 230V power to 120V, but you cannot get a transformer that will convert from 50Hz to 60Hz. Often, US equipment can work, except that they will work hotter and less efficiently on the 50Hz power. Consult your clipper and trimmer documentation - you may find that it will work just fine on 50Hz.
It will not work at all.
What effect will be there on the motor (Induction) output power when a 100kW 50hz motor is connected to a 60hz power supply.
you can't
You don't.
No 50Hz
10HZ. Enjoi!
ONE THING FOR SURE THERE IS NO CHANGE IN VOLTAGE IF SAME EQUIPMENT WE ARE TALKING ABOUT. THE ISSUE HERE IS THE CHANGING LOAD FREQUENCY 60HZ TO 50HZ OR VICE VERSA. FOR EXAMPLE THE MOTOR HORSEPOWER AND R.P.M. WILL BE APPROXIMATELY 90 AND 83 PERCENT OF THE NAMEPLATE SPECIFICATIONS, ALSO THE FULL LOAD RUNNING TORQUE WILL INCREASE APPROXIMATELY 8 PERCENT IF USED FROM 60HZ TO 50HZ.
You can get a transformer that converts the UK's 230V power to 120V, but you cannot get a transformer that will convert from 50Hz to 60Hz. Often, US equipment can work, except that they will work hotter and less efficiently on the 50Hz power. Consult your clipper and trimmer documentation - you may find that it will work just fine on 50Hz.
Voltage has nothing to with frequency
One way would be to hook it up to a supply (by itself, with no load) and measure the speed with a contact tachometer. If your supply is 60Hz, and the motor speed corresponded to one of the standard motor speeds, it would be a pretty safe bet you had a 60Hz motor. If the speed was about 20% faster than a standard speed, the motor is probably a 50Hz motor. Or 20% slower if you were running a 60Hz motor on 50Hz For instance, a 1750 RPM 50Hz motor would spin at about 2100 RPM if you ran it on 60Hz.
No! Normally not, the recistance in the windings is to hig on 60Hz and the pump motor has not power enough to work propelly. This happened to myself when I connected my Whirpool AWE 7519 to 230V 60Hz. Europian model for 50Hz.
No, 120 v is not enough.
Yes, no problem.
No