Radio Shack "drain pipe tracer".
If you are talking about a roof water drain pipe to sewer it is illegal. If you are talking about a sink drain pipe well that is where they all connect to so yea.
2"
You put a drain auger down the pipe from the nearest cleanout. You will feel the blockage when you get to it, - then break it through and clear it with the auger.
It's not the toilet, there's a blockage in the pipes some where after the drain pipe from the toilet joins up with the drain pipe from the tub.You're going to need to have the pipe snaked.
No, stand pipe for washing machine is meant only for washing machine. Tie sink into drain line that washing machine stand pipe is tied into. 2" minimum drain line should be what you tie into. Sink drain line use 1 1/2".
To effectively repair a drain pipe using a drain pipe repair sleeve, follow these steps: Clean and dry the damaged area of the drain pipe. Slide the repair sleeve over the damaged section of the pipe. Tighten the clamps on the sleeve to secure it in place. Test the repaired pipe to ensure there are no leaks.
Foul Air
Yes, a sewage drain pipe can be too large.
If you are talking about a roof water drain pipe to sewer it is illegal. If you are talking about a sink drain pipe well that is where they all connect to so yea.
dvw pipe = drain, waste and vent pipe.
About 10 minutes if they know what they are doing
As long as the pipe going into the wall is straight, the rest of the drain pipe can be routed however it needs to be. Very often the trap is at an angle to the pipe in the wall.
There are multiple reasons to get your drain pipe inspected. One major reason to inspect a drain pipe is before buying a house to make sure everything runs correctly.
A standard sink drain pipe is typically 1 1/2 inches in diameter.
To install a rough-in sink drain, follow these steps: Measure and mark the location for the drain pipe. Cut a hole in the wall or floor for the drain pipe. Install the drain pipe and secure it in place. Connect the drain pipe to the sink drain opening. Test the drain for leaks and proper drainage. Seal any gaps or joints with plumber's putty or silicone sealant. These steps should help you successfully install a rough-in sink drain.
The gradient of a drain is the slope or incline of the drain pipe. It represents the change in elevation of the drain pipe over a certain distance. A steeper gradient indicates a faster flow of water through the drain.
The cost to replace a cast iron drain pipe can vary depending on factors such as the length of the pipe, the complexity of the installation, and the location of the pipe. On average, homeowners can expect to pay between 1,500 to 3,000 for a professional to replace a cast iron drain pipe.