Yes just connect any line to neutral you have 230volts already.
no
Yes. It will make your motor a little faster though, so it depends on what you are powering with this motor. IE Can the piece of eguipment be ran faster?
The motor will run, probably at nearly the same speed, but it cannot supply the same mechanical load. If it can be run on a lighter load, proportional to the voltage, it should be OK.
First of all, your power source must be 3-phase if you want to run the motor, then you need a step-down 3-phase transformer to give 220v 3-phase output.
NO dear we can not rotate a 110 vlolt motor on 220,but if your voltage is 110v then y can rotate it on 50hz ,no problem,but it will rotate at lower speed, ENGR. NASEER AHMED,PAKISTAN
Not advisable, the voltage differential is too great.
no
Yes. It will make your motor a little faster though, so it depends on what you are powering with this motor. IE Can the piece of eguipment be ran faster?
Yes it can run because motors have 10% voltage variation tolerance so it can operate between 380v - 440v band.
Short answer: No. (unless you like ruining motors) Longer answer: Not really, but there are some motors that can be re-wired so that instead of 440v they will run on 220v. However, this is not that common. Conclusion: Check the motor to see if it is dual-voltage on it's nameplate. If it is, you can re-connect it to work on 220v. If it is NOT a dual-voltage motor, you will absolutely ruin it if you connect it to 220v.
The motor will run, probably at nearly the same speed, but it cannot supply the same mechanical load. If it can be run on a lighter load, proportional to the voltage, it should be OK.
Yes, it will run drawing little more extra current in similar conditions. The motor is expected to be running in lesser rpm as well.
If you have a transformer with an output adequate to run the motor, use it directly for the supply to the motor control circuitry. Remember when dealing with motors, the start current will be about 300% of the full load running amperage. Size the transformer accordingly.
Short answer: No. (unless you like ruining motors) Longer answer: Not really, but there are some motors that can be re-wired so that instead of 440v they will run on 220v. However, this is not that common. Conclusion: Check the motor to see if it is dual-voltage on it's nameplate. If it is, you can re-connect it to work on 220v. If it is NOT a dual-voltage motor, you will absolutely ruin it if you connect it to 220v.
First of all, your power source must be 3-phase if you want to run the motor, then you need a step-down 3-phase transformer to give 220v 3-phase output.
Probably .. the fan will run a bit slower and the motor will get a bit hotter the timer will change from 1 hr to 1.16 hours
Most 220 volt equipment will work on 208 volt supply. If the machine has a resistive load then the watts output will be lower than if supplied from a 220 volt source. If it is a motor load you will find that the equipment may run a bit slower but most motors will take the lower voltage. If the machine is a plug in device, install the appropriate receptacle to match the pin configuration and plug it in. If it is a hard wire installation this should be done by a qualified person.