As we all know, Transformers are majorly used in substations. Transformers are specified with their Copper loss & Iron loss impedance (similar to resistance in DC circuits) which are generally considered with AC supply. Therefore, we can calculate the total impedance by
Here, you'll have to consider if the transmission is double circuited or else likewise.
You have to measure the voltage, and the current. The resistance is then calculated by using Ohm's Law.
You can use a multi-meter to measure resistance. The specific portion of the meter for measuring resistance is called an ohmmeter.
Wheatstone bridge is used to calculate the resistance of unknown resistor in the circuit.
Most multimeter are able to measure resistance.
A substation is not a load but is a place where switching and voltage-level changing takes place. Accordingly, you cannot apply a 'power factor' to a substation.
Your measure resistance in OHMS ΩOhms.
A substation that is smaller than the average substation. A substation converts electric power from one voltage to another.
I think it measures characteristics of soil to determine its suitability underneath a plant or substation. One way to measure resistance of the earth is with four conductors in a straight line -- the two outer ones inject a current, and the two center ones measure the voltage. From these two known quantities and Ohm's Law, R=V/I gives the resistance. Earth is not a great "earth," and electrical equipment and building designers strive for a resistance of one ohm. The earth seldom rarely complies with this.
The Substation which comes power from the power plant know as pooling substation.
The ohmmeter is usually used to measure the resistance of a given wire only.
Neuhof Substation was created in 1985.
Jefferson Substation was created in 1909.
You have to measure the voltage, and the current. The resistance is then calculated by using Ohm's Law.
used to measure low Resistance since it must reach a null.
Ohms measure electrical resistance. The resistance in ohms is the voltage divided by the current.
You can use a multi-meter to measure resistance. The specific portion of the meter for measuring resistance is called an ohmmeter.
Concourse Yard Substation was created in 1933.