answersLogoWhite

0

Mix up a glob of JB Weld and then screw the cap in. Once that sets, it is never coming out. The other answer would be to get a rubber connector boot bigger than the pip and connect a new piece of PVC which you could cap. vbd Purchase a No-hub clamp at a Plumbing supply house, along with a cap, or cleanout plug. The No hub clamp slips over the damaged threads, and connects the new fitting. Tighten the screws. Done! There is a plug availible, rubber with a washer each side and a bolt running thru it with a wing nut on the top side. Simple insert into the hole and tighten the wingnut. This compresses the rubber causing it to swell out and plugging the hole.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

How do you clean rusted thread on galvanized pipe?

I find a wire brush is usually enough to clean threads.


How do you remove rust from your tools without ruining the finish ie wire wheel?

One way to remove rust from tools without damaging the finish is to use a mixture of vinegar and baking soda. Soak the tools in vinegar for a few hours, then scrub with a paste made of baking soda and water. Another method is to use a rust remover specifically designed for tools; follow the manufacturer's instructions carefully to preserve the finish.


How do you remove rotors that are rusted on?

Hit it with a hammer


How do you remove muffler rusted to pipe from converter?

Hacksaw


How can you get a new PVC screw cap to attach to an old worn and rusted threading on a pipe?

Use pipe die on worn threads if you have enough room for die to fit. If not, clean threads with wire brush.


How do you remove a rusted trailer hitch?

A cutting torch is one answer.


How do you remove a distributor cap screw bolt rusted stuck without destroying distributor?

Most of the time it breaks off and you will need to drill it out and replace screew.


How do you remove male pipe threads from cast iron female The rusted pipe broke off at the level of the cast iron in a hard to reach area It is for bathtub drain connection to septic tank Can you heat?

NO you cannot heat as any flame can cause a severe explosion and the very least crack the CI fitting The threads have to be cut out gently and possibly re tapped


How can I effectively remove rusted bolts from a toilet?

To effectively remove rusted bolts from a toilet, you can try using penetrating oil to loosen the rust, using a wrench or pliers to carefully turn the bolts, or using a hacksaw to cut through the bolts if they are too stubborn. Be sure to use caution and wear protective gear when attempting to remove rusted bolts.


How do you remove rusted bolts from an old toilet that has ceramic bolt tops that can't be removed?

Bad news. I have found it impossible to remove the bolt caps without breaking them. They are mortared on. They do make plastic bolt caps in a lot of different colors.


How do you remove rusted front rotors off a 1999 ford windstar?

a large hammer


HOW TO Remove a rusted broken off piece of metal from inside plastic part?

A magnet