i know that an op amp can be used as an amplifier and a switch, but i want to have more uses of the component or device.
A: Any offset whether is voltage or current is an output error to contend with.
yes, with additional circuitry. an opamp wired as a differentiator followed by an opamp wired as a comparator can provide short timing periods. an opamp wired as an integrator followed by an opamp wired as a comparator, plus some other circuits left as an exercise to the reader can provide long timing periods.
A practical opamp is designed to approach the characteristics of the ideal opamp as closely as possible. The open loop voltage gain of an ideal opamp is infinite, so while this is actually impossible to achieve practical opamps are built with as high an open loop voltage gain as possible.
741 opamp
An opamp buffer circuit is one where the input signal is connected to the plus input, and the output is connected to the minus input. Within the performance limitations of the opamp, the output will track the input. The advantage of the buffer circuit is that is presents very little load impedance to the input signal, while providing a low impedance from the output to drive whatever circuitry is connected there.
A high CMRR prevents the opamp from passing undesirable common mode signals.
Beretta 92FS with compensator - 9mm
A: Any offset whether is voltage or current is an output error to contend with.
A comparator is simply an opamp with a certain configuation of external circuitry ( a few components) that make it function as a comparator.
yes, with additional circuitry. an opamp wired as a differentiator followed by an opamp wired as a comparator can provide short timing periods. an opamp wired as an integrator followed by an opamp wired as a comparator, plus some other circuits left as an exercise to the reader can provide long timing periods.
A compensator for looks only. Air soft "weapons" don't generate enough recoil for one to be needed.
The compensator is causing the action to bind, or the additional weight is preventing the slide from moving freely.
no, the 741 opamp is a monolithic IC.
It is an opamp chip consisting of 8 pins
A practical opamp is designed to approach the characteristics of the ideal opamp as closely as possible. The open loop voltage gain of an ideal opamp is infinite, so while this is actually impossible to achieve practical opamps are built with as high an open loop voltage gain as possible.
The compensator torque specifications for a 1975 Harley-Davidson FLH typically require the compensator nut to be torqued to 65-75 ft-lbs. It’s important to use a torque wrench to ensure accuracy and avoid damage to the components. Always refer to the specific service manual for detailed instructions and specifications, as they can provide the most reliable guidance for maintenance and repairs.
An op amp is made from transistors, resistors and capacitors. It is enclosed in a "chip". A basic instrumentation amp is made of 2 op-amps. you can't have a single op-amp perform as good as a instrumentation amp, although it can perfrom the same task. An i-amp has much better CMMR (common-mode rejection) and a higher input impedance.