answersLogoWhite

0

shear plane angle is Eric siangco + hulian lastontas = shear plane angle

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you calculate vertical thickness and true thickness?

To calculate vertical thickness, you can use the formula: Vertical thickness = True thickness / cos(strike angle) To calculate true thickness, use the formula: True thickness = Vertical thickness * cos(strike angle)


Idea for projets using rack and pinion mechanisms?

pump machining industry major problem are right angle machining problems are faced.so indexing mechanism are used this problems


What materials are machined by low helix angle drill bit?

low helix angle drill bits are used for machining hard materials


How do you calculate angle bar weight?

In order for your to know the weight must know the thickness of the angle bar.


When chip thickness ratio greater than 1?

When Rack angle is zero... Chip thickness ration is going to be greater.


What are the function and purpose of rake angles?

Rake angle is usually used for cutting and machining processes. This can vary according to the materials being cut and set-up. The two types of rake angle are the back and side rake angle.


What is the unit weight of angle 50X50X6 mm thickness?

The unit weight of an angle with dimensions 50x50x6 mm thickness can be calculated using the formula: (width + height - thickness) x thickness x 0.00785. Substituting the values, (50 + 50 - 6) x 6 x 0.00785 = 3.35 kg/m.


Why do the focal length decrease as the thickness of the lens increase?

The angle of refraction increases, though it's a function of curvature rather than actual thickness.


When using hexagonal writing to narrow a topic which is not an angle from which to look at a piece of literature?

An introduction is not an angle from which to look at a piece of literature when using hexagonal writing.


Why do tanks have sloped armor?

When you put the armor at an angle, the thickness is increased due to the fact that it is sloped as opposed to plumb.


How do I know or calculate the load that a 2 inch .25 thickness angle iron can support?

First, consider how the angle is supported and how the load is applied, then apply the applicable Strength of Materials equations for that case.


What has the author Boniface Edem written?

Boniface Edem has written: 'Winds against progress' -- subject(s): Fiction