answersLogoWhite

0

The two sources add together, imposing a DC bias to the AC source.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Can you connect an AC source in series to DC source - then what happens to the current under a steady state condition?

With an AC and a DC voltage source in series, the DC voltage can be added to the RMS value of the AC voltage to give the effective voltage.


How does capacitor discharge while ac supply is on?

For part of the AC voltage wave, the capacitor will be above the source voltage, and will discharge until the AC voltage wave increases above the capacitor's stored voltage.


Is DC is at low voltage than ac?

There's no correlation between the voltage, the current, and whether the source is AC or DC.


What can a DC voltage be produced by?

A: AC recitification and battery source.


What happened if the DC voltage in the clamping circuit is replaced by an AC source?

we will get rectified voltage at the output.in case we replaced the DC source with AC source


Why do the voltage drops of an inductor and a lamp in a series ac circuit not equal the applied voltage?

The voltage is greater than the applied voltage, why?


What will be the combined voltage if AC and DC in series circuit?

the sum of the two


How do you use a resistor to lower ac voltage?

ummmmm... put it in series.


How does the maximum value of the current depend on the frequency of the AC voltage source?

The maximum value of the current in an AC circuit depends on the frequency of the voltage source. As the frequency increases, the maximum current value also increases.


What is an ac reactor?

A reactor in an AC circuit is basically an inductor which will filter spikes in source voltage. See the related link.


What are voltage dividers?

Voltage dividers are used in a linear circuit to separate the input voltage into a small portion known as the output voltage. It is commonly used to get a low voltage signal equal to the voltage being measured.


Can a diode work in ac?

A diode is a "one-way valve" that allows electrical current to flow in only one direction. A diode placed in series between an AC voltage source and a resistive load will allow current to flow through the load in one direction and block the current when the polarity of the AC voltage changes.