An open circuit or a short-circuit (if that circuit is complete).
As load is conected in circuit , so thre is no open circuit therefore there would not be any open circuit voltage.
For a d.c. circuit, you divide its supply voltage by the resistance of its load. For an a.c. circuit, you divide its supply voltage by the impedance of its load.
A load not connected to ground but connected in a feedback circuit is floating load
A circuit named for its type of load is often referred to as a "load circuit." This type of circuit specifically describes the electrical load it serves, such as resistive (like heaters), inductive (like motors), or capacitive loads (like capacitors). The classification helps in understanding the behavior and requirements of the circuit, including power consumption and load characteristics. Such distinctions are important for designing and managing electrical systems efficiently.
The circuit will become an open circuit.
The load of a flashlight is the bulb.
No. No load and short circuit is not similar. No load can be 1) Either open circuit i.e. Only Potential is available and load is not connected 2) Load (i.e. motor etc ) is connected but not working with full load or full capacity. In this case the current will flow through the circuit depending on the load. It means No load condition is a condition where no current or a small ( relative / comparative term) current is flowing through the circuit. In Short circuit the load side resistance/ impedance become so less that very high amount of current is passing through circuit.( The protection is therefor required for any circuit) No load and and short circuit is not similar. Thanks
A load increases the flow of electrical current in a series circuit. No load, no flow.
As load is conected in circuit , so thre is no open circuit therefore there would not be any open circuit voltage.
the electrical circuit, load, conductor, open circuit, switch,
The bulb is the load of the circuit, without it you have a short circuit.
this is a circuit in which the switch is located before the load in the circuit
For a d.c. circuit, you divide its supply voltage by the resistance of its load. For an a.c. circuit, you divide its supply voltage by the impedance of its load.
No, a switch is not considered a load in an electrical circuit. A switch controls the flow of electricity to the load (such as a light bulb or motor) by opening or closing the circuit. The load is the component in the circuit that consumes the electrical energy.
A load not connected to ground but connected in a feedback circuit is floating load
this is a circuit in which the switch is located before the load in the circuit
The current in a circuit is reduced to prevent the circuit from over load.