Measure the outer diameter of the tube and its' length. Calculate each tube volume and multiply by number of tubes. For those who want to calculate the inside liquid capacity of the shell side, it is advise to include the baffle volume with the tube bundle volume.
A tube light uses a condenser which is the old term for a capacitor. It functions as a small battery in a circuit.
The factors that are affected by number of tubes in shell and tube heat exchanger is the rate of heat transfer and flow rate.
increase to heat transfer coefficent
Tube pitch is the center-to-center distance between parallel straight tubes in a uniform bundle. The tube layout pattern is usually triangular or square. The tube pitch is usually about 1.25 times the outer diameter of the tubes.
A heat exchanger with straight tubes in a shell that can normally be mechanically cleaned
Measure the outer diameter of the tube and its' length. Calculate each tube volume and multiply by number of tubes. For those who want to calculate the inside liquid capacity of the shell side, it is advise to include the baffle volume with the tube bundle volume.
Water vapor condenses in a cold condenser tube.
A tube light uses a condenser which is the old term for a capacitor. It functions as a small battery in a circuit.
Importance to keep inner tubes of condenser cold
where is the ac condenser drain tube on a 2008 Saturn Outlook.
Importance to keep inner tubes of condenser cold
Its in the outlet of the condenser.
It is located in the liquid(lower) line at the condenser. This line runs from condenser to accumilator.
It is in the condenser at the connection to the liquid line. This is the line that comes up from the bottom of the condenser.
Most GM's put the orfice tube in the output side of the condenser, near the bottom. Locate the fitting that runs from the condenser to the firewall, open that fitting and the orfice tube should be inside.
It is located in the inlet tube of the evaporator between the outlet of the condenser and the inlet of the evaporator. This point can be found in a properly functioning system by locating the area between the outlet of the condenser and the inlet of the evaporator that suddenly makes the change from hot to cold. You can see small dimples placed in the line that keep the orifice tube from moving inside the tube. It is located just a few inches outside of the condenser in the tube.