answersLogoWhite

0

What else can I help you with?

Continue Learning about Engineering

When electricity leaves the power plant it is measured in what unit?

There are lots of different units for electricity, depending what aspect you want to measure (power, energy, current, voltage, frequency, etc.).For a power plant, some relevant units include: * Volt, for voltage * Ampere, for current * Watt, for power * Hertz, for frequency


What is 1 unit of ohms?

Ohm's Law: voltage = current x resistance. The SI units involved are the following:Voltage: voltsCurrent: amperesResistance: ohms


How many joules equals 1 kilo amp?

This is not a valid question by itself. Joules are units of energy, while Amps are units of electrical current. However, if you also know the Voltage of the electrical current, you can multiply the Current[Amps]*Voltage[Volts] to get the Power in Watts. Watts are equivalent to Joules per second. If you then know the amount of time of the current flow, you can calculate the total number of Joules by multiplying the Power[Watts]*Time[seconds] = Energy[Joules] .


If voltage stays the same and resistance increase what happens to electric current?

If voltage increases and the resistance stays the same the current must increase. According to Ohm's LawV~I (Directly Proportional) and V=RI where R is the constant of Proportionality, Resistance.


How are voltage and current measured?

ElectricalElectrical current is measured with an ammeter and in units called amperes, or amps.Stream FlowRiver flow or current (discharge) is measured in cubic feet per second or cubic meters per second.

Related Questions

List the units for measuring current and voltage?

The unit of voltage is the "volt". The unit of current, sometimes called "amperage", is the "ampere".


What are the units for measuring a) current and b) voltage?

Amperes and volts, respectively.


Is The units of electric current is the volt?

NO! (the units of electric current is Amperes).


Is units of electric current a volt?

Electric current is measured in amps not voltsElectric voltage is measured in volts.


Is ohm's law in Vrms or Vpp?

It doesn't matter as long as you measure both voltage and current in same units.


What is the standard unit used to measure Voltage?

Voltage: The proper term is 'electromotive force'. It's measured in volts.Current: Measured in amperes.Resistance: Measured in ohms.


How many volts to make one watt?

Wattage refers to power power is voltage times current. P = V*I Therefore, in order to know the voltage you need you also need to measure the current (units of amps).


What is Function of a power supply?

Power supplies are normally units that adapt the incoming current from a "mains" source and convert it to a lower (regulated) voltage that can be used by an appliance. They are commonly found in computers, charger units, low voltage lighting systems etc.


When electricity leaves the power plant it is measured in what unit?

There are lots of different units for electricity, depending what aspect you want to measure (power, energy, current, voltage, frequency, etc.).For a power plant, some relevant units include: * Volt, for voltage * Ampere, for current * Watt, for power * Hertz, for frequency


What would be the starting current of any Air Conditioning if voltage is 220?

To calculate the starting current of a motor, the run current must be stated. The voltage is only associated with this calculation in as the higher the motor's voltage is the lower the run current is. The start current can be as high as 300 to 600 percent of the run current. Also taken into account, without the specific make and model of the A/C, the run current is hard to guess as there is quite a variety of amperage drawn by these units.


If you multiply electric current times resistance what will it be in units?

That depends on what units you use as input. If you put in current in Amps and Resistance in Ohms you will get voltage in Volts.AnswerCurrent is measured in amperes. Resistance is measured in ohms, which is a special name given to a volt per ampere. Multiply amperes by (volts per ohm), and you are left with volts.


What is the name of an instrument for measuring electrical current?

A multimeter is a common instrument used to measure electrical current. It can measure current, voltage, and resistance in electrical circuits.