When dealing with a 3 phase power supply the safe clearance zone between each phase is usually within an arms reach, there are exceptions to this rule like a 3 phase socket or a distribution board.
Across a 480 volt three phase system, 480 volts should appear across L1 and L2, L2 and L3 and L3 and L1.
Yes
Current in 200kw at 480 volts = 200,000/480 = 416.667 amps
You should not need a wiring diagram. If the generator has a star point (wye) connection then the phase voltage to ground (star point) is 277 volts. 480/1.73 = 277.
200 and 100
Can I run 480 volt , 60 HZ motor at a 380 volt , 60 Hz system?
Yes 480 volt electric wiring can be run in emt conduit.
480 volts and 60ohm impedence current = volt/impedence current=480/60 current=8ampeares
Across a 480 volt three phase system, 480 volts should appear across L1 and L2, L2 and L3 and L3 and L1.
Yes
The conductor for H2 connection on a 480 volt wire transformer should be marked:
Current in 200kw at 480 volts = 200,000/480 = 416.667 amps
No, it is not recommended to run a 570 volt motor on a 480 volt power supply. The motor is rated for a specific voltage to ensure optimal performance and prevent damage. Running the motor at a lower voltage could result in overheating and premature failure.
You should not need a wiring diagram. If the generator has a star point (wye) connection then the phase voltage to ground (star point) is 277 volts. 480/1.73 = 277.
with 3 phase lighting you do not have to use as large of wire and can use one neutral for every 3 current carrying conductors so it cut down on material costs ( as voltage increases current decreases) <<>> The voltage 277 is the star-point voltage of a 480 volt three phase system. By using a 480 volt wye system you have the dual ability of running 480 volt three phase equipment along with 277 volt lighting. The side advantage is the ability of using the phase voltage to ground (neutral) 480 / 1.73 = 277 volts for general lighting of the building the 480 volt equipment is located in.
Your question answers itself... 1000 watts, when operated on a 480-volt source..
No. Not safe to do so. The distances between contacts may not be sufficient.