answersLogoWhite

0

In its simplest use a resistor in a circuit is used to limit the amount of current flow, or to decrease the amount of voltage applied to a device. One example is you had a 12 volt battery and you need/ wanted to connect it to a device that ran on 9 volts then a resistor can be chosen to reduce the 12 volts to the 9 volts required.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How does a resistor TBA820 work?

The TBA820 is a 2 watt general purpose amplifier integrated circuit, not a resistor.


What is need of capacitor and resistor in circuit?

because without using capacitor or resistor in a circuit,it cant be complete.Resistor is used to protect the circuit by giving a certain amount of voltage.Capacitor is used to charge and discharge purpose.


What is the usage of 330 ohm resistor?

No. It will not serve its intended purpose.


How do you install a resistor in an DC circuit?

It depends on the purpose for installing the resistor. If the intent is to decrease current flow, the resistor must be connected in series with the load. If the purpose is to increase current flow, the resistor must be connected in parallel with the load. To connect a resistor in series, connect the resistor to one side of the power source, in line with the load. This will decrease circuit current flow. To connect a resistor in parallel, connect the resistor between the positive and negative sides of the power source, which will effectively connect the resistor across the load . This will increase current flow through the circuit. However, before connecting a component in parallel, make sure the increase in current flow will not exceed the current rating of the circuit or fuses/breakers will blow.


What is the purpose for circuit breakers?

To avoid shocks and to avoid damage to the electronic gadgets


Describe the purpose of the coloured bands on a resistor?

The colored bands on a resistor indicate its resistance value and tolerance. By interpreting the color code, you can determine the resistance value of the resistor and the range within which the actual resistance may vary. This helps in identifying, sorting, and using resistors in electronic circuits.


What is the purpose of the individual modules or components within an electronic circuit?

To pass current very easily from one part of a circuit to another.


What happens if a circuit has no resistance?

Then the voltage in will equal the voltage out. The purpose of a resistor is to reduce the amount of electrical flow of current. You 'short out' the supply and blow a fuse/circuit breaker.


What is the purpose of a resistor?

A variable resistor is used in cicuits to vary the current passing through the resistor. It is commonly used to change the value of current across a circuit, or to act as a voltage divider. They are commonly equiped with a knob outside of a cabinet, to enable the user to adjust the operation of a circuit, like a volume control on a radio or amplifier.


What is general purpose resistor?

General purpose resistor is used to resist the current flow.the common resister is general purpose resister.


How do you use the Transistor output terminals of an electronic counter in a Electrical control circuit?

They use transistor as the purpose to transfer the voltage


What is the purpose of a rheostat in the determination of an unknown resistor?

A rheostat can be used to vary the resistance in a circuit until a balance condition is reached, allowing for the determination of the unknown resistor value through adjusting the resistance of the rheostat until the circuit is balanced. This process is often used in bridge circuits for precise resistance measurements.