The only effect the sun has on PVC pipes is the impact strength of the pipe will be decreased and there will be some discoloration. The tensile strength and pressure strength of the pipe will not be effected. The best way to protect the pipe is to paint it with a water based latex light colored paint.
You can put up to a 2 inch pipe into a 4 inch. If you are putting 4 inch to 4 inch, either take out a section of the cast and put the PVC in or cut out a section and connect the PVC to the cast with rubber sleeves meant for this. You can use a saddle clamp for the 2 inch. It is a half round piece of PVC with a 2 inch connection in it. It is held on with two U bolts that go around the cast pipe. Put it where you need it and mark the 2 inch hole on the cast. Drill a series of 1/8 inch holes around this circle. when you get them all drilled, you can break out the plug. Try to keep it from falling into the cast pipe. Put the saddle clamp on and connect the PVC pipe as needed. Seal the saddle clamp to the cast pipe with plumbers putty.
Most of the time it is 4 inch.
Yes
It depends on the pipe schedule and diameter... For example. Schedule 40 1 Inch pipe has a minimum burst pressure pressure rating of 1440PSI and an operational PSI of 270. Google can provide a complete chart. Just search "PVC Pipes - Pressure Ratings"
The only effect the sun has on PVC pipes is the impact strength of the pipe will be decreased and there will be some discoloration. The tensile strength and pressure strength of the pipe will not be effected. The best way to protect the pipe is to paint it with a water based latex light colored paint.
It should, are you sure your pvc pipe is round
What schedule pipe?
Water flow rate half inch PVC pipe 65 psi?
The outside diameter of a 1/2 inch PVC pipe is approximately 0.840 inches.
The outer diameter of 1/2 inch PVC pipe is approximately 0.84 inches.
Probably the wrong size flange. Is the flange a toilet collar? If so the pipe is probably 4 inch.
The maximum pressure rating for a 2 inch schedule 80 PVC pipe is typically around 400 psi.
The maximum pressure rating for a 2 inch schedule 80 PVC pipe is typically around 400 psi.
this depends on the class of the pipe as the higher the class the thicker the pipe
The maximum weight capacity that can be supported by a 2 inch schedule 40 PVC pipe is approximately 250 pounds.
The recommended installation procedure for schedule 80 4 inch PVC pipe involves cutting the pipe to the desired length, cleaning the ends with PVC cleaner, applying PVC primer, and then using PVC cement to join the pieces together. It is important to ensure the pipe is properly supported and aligned during installation to prevent leaks or damage.