About a million and a half. As far as an exact number? They're bought in pounds, so not even Boeing knows. how many rivets used to construct the Boeing 747-100 series aircraft
About 8 hours. The B747-200 had a fuel capacity of 330,000 lbs and used approximately 25,000 lbs per hour. The USAF E-4 Airborne Command Post is a highly modified B747-200 that has in-flight refueling capability and extra tank for engine oil and it can fly 3 days without landing.
The border line
The average cost to clean fuel injectors is about $150. Fuel injectors are used to deliver fuel into an internal combustible engine.
1/2" water lines. Drain line determined by flow rate of showerheads and bodysprays being used. 5.7 gpm or less flow rate would need 1 1/2" drain, which is minimum size allowed.
A fuel line is a hose that is used to transport fuel from one point in a automobile to another. Fuel line sizes differ from one type of vehicle to another.
While the actual fuel consumptions of the Boeing 737 depend on several factors there is an average that is widely used. It is estimated that the Boeing 737 uses about one gallon of fuel every second.
The Boeing 777 uses an airplane grade of diesel similar to that of diesel trucks. Type #2 Kerosene is the diesel fuel used for the Boeing 777. The Boeing 777 has a higher fuel capacity and is more efficient at fuel consumption than earlier models like the 747.
The Mercury 40 HP outboard typically requires a fuel line size of 5/16 inch (8 mm) in diameter. This size is designed to handle the fuel flow necessary for optimal performance of the engine. It's important to ensure that the fuel line is compatible with the type of fuel being used and to check for any specific manufacturer recommendations in the owner's manual.
A Boeing 767 airliner uses standard Jet-A type fuel. It is based on kerosene unlike gas used in automobiles.
That is dependent on how heavy it is. Full thrust requires the most fuel. Too many variables to answer sufficiently
I just had to patch a cut fuel line on my 93 S10 4.3l V6 and used 3/8" compression fittings, so I would say 3/8" steel line.
A 747 uses about 24 gallons of fuel per hour while taxiing. The actual amount of fuel used during taxiing can vary depending on the size of the airport and other factors such as traffic congestion and taxiing distance.
fuel return line.
The fuel filter on one end requires a special fuel line removal tool. The tool slides into the fuel line and releases the internal clips. Lappens has a fuel line removal kit for rent. Uses the same tools that are used to disconnect the a/c hoses. The come in a set for different size lines. Cost about $10.00.
A Boeing 747-200 burns about 25,000 Lbs of fuel per hour. That would total 100,000 lbs in 4 hours. As I recall, the max fuel load is 330,000lbs.
The most commonly used type of Boeing aircraft is the Boeing-747 passenger jet. This airplane is used internationally to carry people all over the world.