That is not a simple anwer. It depends on the roof design and how many, and where the load points are, and the material of the beam(wood, metal, composite). See a structural engineer.
1'*1'
The size of the beam needed to span 10 feet for roof support depends on various factors, including the type of material (wood, steel, etc.), the load it will carry, and local building codes. For a typical wooden beam, a common choice might be a 2x10 or 2x12, but calculations based on specific load requirements and spacing are essential. It's advisable to consult a structural engineer or local building codes to determine the exact specifications for safety and compliance.
That depends on what it is carrying. . .you definitely need to consult a structural engineer for this information, and having the original set of plans to show him will help. FYI. . .28 feet is a VERY long clear-span for any type of beam.
You must also take in consideration the width of the building. For instance a 12'x16' building you would use 2x6 rafters and a 2x8 beam with collar ties every 4'.
With a span of only 8" you can probably use a wood beam, but without a set of plans no one can accurately answer your question.
1'*1'
The recommended patio roof beam span according to the patio roof beam span table is typically around 10-12 feet.
Roof Line 30 Foot Span
That question cannot be answered without knowing the load on the beam.
What size steel I beam do I need to span a 32 feet garage with a floored storage above and no posts
To span a distance of 20 feet, a lumber beam of at least 2x10 size is typically needed for adequate support.
It depends on the roof load and the actual clear span. Off hand, I would guess htat you haven't given this much thought. A rule of thumb for a steel truss is one inch per foot of span or in your case 40 inches. If you want to use a steel I-beam, you can get that from a good municipal library from the steel beam institute, but you are going to need a crane to place it. Dieter in Cincinnati
250 Feet
The size of the beam needed to span 10 feet for roof support depends on various factors, including the type of material (wood, steel, etc.), the load it will carry, and local building codes. For a typical wooden beam, a common choice might be a 2x10 or 2x12, but calculations based on specific load requirements and spacing are essential. It's advisable to consult a structural engineer or local building codes to determine the exact specifications for safety and compliance.
250 Feet
250 feet
38 feet longIt is not possible to give a definite answer without more detail. The construction and type of roof will determine the load (weight) bearing on the beam, and factors such as wind load and earthquake load, and the way the roof bears on the beam (truss/point load/distributed load) will all affect the sizing.