0
What else can I help you with?
How do you connect copper pipe?
YOU thread or braze copper pipe Copper tubling you solder, braze, flaire, compression ring, mechincal joints
How do you weld copper piping?
you solder or braze it
Can you braze tin?
In short, no you can't braze tin.Assuming that you are using a fairly standard set-up with an oxyacetylene torch you will burn straight through most grades of tin.
Can you braze copper to galvanize?
Yes with a 25 M bronze rod made by union carbide
How do you make reducer from pipe?
By placing a smaller pipe insider the larger one and weld /braze the gap
How do you braze metal?
You use an acetylene torch and special brazing rods.
Can you braze popmetal?
Pot metal-no. Better to use jb weld or something.
How do you solder steel and copper?
You cannot solder Steel BUT you can braze steel and copper and you can thread steel and then use a copper x female adapter Or finf a steel fitting and use a C x M adapter
How do you braze brass tubing closed?
with a copper self fluxing brazing rod type suggested by AWS
What type of drumsticks do the drummer from Nickelback use?
Regal Tip I think :)
Do you need pipe dope to connect brass pipe to copper pipe?
NO but you will need some type of sealent OR braze or soldering
Why use flux when soldering copper tube?
To prevent oxidation and allow the alloy to flow into the fitting capillary action (attraction) and it is best to use a non acid flux and if one knows how to braze they can braze joints with a tensile strength of 87,000 PSI without the use of flux PROVIDING you use the correct rod as per AWS
How do you braze brass?
Clean the base metal use a high temperature flux using a torch capable of getting the base metal almost cherry red and if you braze the joint properly your tensile strength should exceed 87,000
What should you use to apply lubricant to a gun?
You can use the spray type or liquid type. For the liquid type, you can use a q-tip, small needle, clean patch, clean rag, etc..
What equipment is required to braze metal?
Equipment to braze metal is commonly available in hardware stores and is sold in kits. Typically, it consists of a torch and several types of rods to braze metal. that is not what im looking for yea that is my question
What type of markers can you use to make a custom clone?
you should use sharpie fine tip or normal markers
Do you have to braze 410a?
Yes, its a requirement of all manufacturers, that i know of, to braze 410a connections with a brazing alloy containing a minimum of 15%
