The magnetic field lines (the lines of force) around the magnet sweep the windings in the coil. This induces a voltage in the windings (through induction), and the voltage will try to drive current if it can. There is a bit more to this, but the essential elements are that the magentic lines of force cause voltage in the coil because there is relative motion between the field and the coil.
Inside a microwave oven,microwaves are made when electricity passes through a device called Magnetron.Magnetron uses a strong magnet. The electricity and the magnet make microwave electromagnetic.
You need a strong magnet, a big coil of enameled copper wire, a large capacitor, and an efficient LED. And a few odds and ends. The basic design uses the magnet and coil as a generator, or dynamo. As you shake the assembly, the magnet slides up and down past the coil, generating voltage. You rectify the AC voltage and use it to charge the capacitor. You then discharge the cap through the LED to make light.
the process of converting iron to a permanent magnet is called magnetization. As iron is a ferro magnetic material it is magnetized by applying strong magnetic field across it , this makes the alignment of all the magnetic dipoles present in iron in the same direction .Even after the external magnetic field is removed they retain their arrangement , thus it becomes a permanent magnet
Use a acid strong enough to burn through dirt but not strong enough to burn through metal adicdasy level should be around 1.5.
Unlike a permanent magnet, an electromagnet can be turned on and off. One useful advantage of this: Place a metal bar inside the electromagnet, apply current through the electromagnet in one direction, and the magnetic field would move that bar one way -- reverse the current reverses the magnetic field and the bar would move the opposite way. You could use that effect and make an electronically controlled lock for a door.
The electrons of the permanent magnet would align the way the electromagnetic field passed through the magnet.
yes a strong magnet can do
it creates a very strong magnet A+ users
You can strengthen a magnet by exposing it to a strong magnetic field, either by placing it near another strong magnet or using an electromagnet. You can also induce a current in the magnet by tapping it with a hammer or passing an electric current through it to realign its magnetic domains and increase its strength.
Sound is made by pushing air with the cone. A coil of wire is attached to the cone. The "sound"current is passed through the coil. Any current running through magnetic flux causes the coil and cone to move. The larger the magnet the louder the sound. A strong permanent magnet is used. Electromagnets are not used, however
Sound is made by pushing air with the cone. A coil of wire is attached to the cone. The "sound"current is passed through the coil. Any current running through magnetic flux causes the coil and cone to move. The larger the magnet the louder the sound. A strong permanent magnet is used. Electromagnets are not used, however
This is called an electromagnet. When a current passes through a coil of wire, a magnetic field is generated around the coil. This magnetic field creates a temporary magnet that can attract or repel other magnetic materials.
A lodestone is a naturally occurring magnet and is considered to be a strong magnet.
A magnet can move a car, if the magnet is strong enough.
a temporary magnet can be created by an electromagnet but it can also be created by any type of strong magnet
To demagnetize a magnet, you can expose it to high temperatures, pass an alternating current through it, or subject it to strong impacts. These methods disrupt the alignment of the magnetic domains within the magnet, causing it to lose its magnetism.
When a strong beam of light is passed through a colloidal solution, then scattering of light is absorbed.