0
What else can I help you with?
Why Don't we use odd number of tube passes in Shell and Tube Heat Exchanger?
It is difficult from cleaning point of view. Both end chambers have to be removed so as to clean the heat exchanger with odd nos of passes. Thanks & Regards Priyanka Karkera
What is the factors that effect on number of tubes in shell and tube heat exchanger?
The factors that are affected by number of tubes in shell and tube heat exchanger is the rate of heat transfer and flow rate.
How you can increase the retention time in shell and tube heat exchanger?
the most effective way to do so is to reduce the flow of the heat exchanger
How much tube could plug in heat exchanger or in percentage?
about 10% of the total number of tubes
Why impingement baffle is introduced at the shell side inlet of a shell and tube heat exchanger?
increase to heat transfer coefficent
Why Don't we use odd number of tube passes in Shell and Tube Heat Exchanger?
It is difficult from cleaning point of view. Both end chambers have to be removed so as to clean the heat exchanger with odd nos of passes. Thanks & Regards Priyanka Karkera
What is the factors that effect on number of tubes in shell and tube heat exchanger?
The factors that are affected by number of tubes in shell and tube heat exchanger is the rate of heat transfer and flow rate.
Where is the dollar plate on a heat exchanger?
It's the flat, flanged cover on the front (and sometimes the rear) of a shell & tube heat exchanger.
How you can increase the retention time in shell and tube heat exchanger?
the most effective way to do so is to reduce the flow of the heat exchanger
Why is there floating head in heat exchanger?
allow for tube expansion
What is the purpose of floating head in heat exchanger?
allow for tube expansion
What are the uses of shell and tube heat exchanger?
phoot key nikal ley beta
What is the use of shell and tube heat exchangers?
shell and tube heat exchangers are used mostly in the chemical processing industry for heating, cooling, condensing, and evaporating highly corrosive liquids and gases. AMETEK Fluoropolymer Product shell and tube heat exchanger was the first heat exchanger developed using fluoropolymer tubes and the patented honeycomb tube to tube sheet joint which has been successfully used for over 55 years. Sulfuric Acid is the chemical most used with Ametek Fpp heat exchangers. The process of making sulfuric acid can vary, but any company dealing with the manufacturing process has a high potential for the use of a fluoropolymer heat exchanger in their process. Other Acids commonly requiring fluoropolymer heat exchangers are Hydrochloric, Nitric and Hydrofluoric Acids. Another chemical manufacturing industry fluoropolymer heat exchangers are used in is the Chlor-Alkali manufacturing process.
What is the assumption to design heat exchanger?
The assumption to design heat exchanger is that it must be a shell and tube device. This device must allow the transfer of heat from one fluid to another without mixing the two fluids.
What is a shell and tube condenser?
A heat exchanger with straight tubes in a shell that can normally be mechanically cleaned
How much tube could plug in heat exchanger or in percentage?
about 10% of the total number of tubes
Why impingement baffle is introduced at the shell side inlet of a shell and tube heat exchanger?
increase to heat transfer coefficent
