If you are placing more than one resistors in series, then its combined resistance is higher than when you place these resistors in shunt.
In a series circuit, the total voltage supplied by the source is divided among the resistors based on their resistance values. According to Ohm's Law (V = IR), a resistor with a larger resistance will have a larger voltage drop when the same current flows through it. Therefore, the resistor with the highest resistance in a series circuit will indeed experience the largest voltage drop. This is because the voltage drop across each resistor is directly proportional to its resistance.
The combined resistance will be 2 Ohms.
If you add a second resistor, the resistance of series circuit will increase.
86k. Resistance in series is the sum of the individual resistors.
Resistors are rated in wattage so the lowest wattage rating will be the wattage of the series circuit. It will be able to handle that power any more and the lowest wattage resistor could be damaged and fail.Another AnswerWhen two or more resistors are connected in series, the resistor with the lowest resistance will operate at the highest power. If the power developed by a resistor exceeds its rated power, then the resistor may burn out.
3
In a series circuit, the total voltage supplied by the source is divided among the resistors based on their resistance values. According to Ohm's Law (V = IR), a resistor with a larger resistance will have a larger voltage drop when the same current flows through it. Therefore, the resistor with the highest resistance in a series circuit will indeed experience the largest voltage drop. This is because the voltage drop across each resistor is directly proportional to its resistance.
The combined resistance will be 2 Ohms.
If you add a second resistor, the resistance of series circuit will increase.
The resistor with the most resistance.
2
In a series circuit, if one resistor is replaced with a resistor of lower resistance, the total resistance in the circuit decreases. This leads to an increase in the overall current flowing through the circuit.
86k. Resistance in series is the sum of the individual resistors.
The voltage across 600 ohm resistor(i.e. between point 'a' and 'b') will be 30V.
the voltage across that resistor will increase if it is in series with the other resistors. the current through that resistor will increase if it is in parallel with the other resistors.
Resistors are rated in wattage so the lowest wattage rating will be the wattage of the series circuit. It will be able to handle that power any more and the lowest wattage resistor could be damaged and fail.Another AnswerWhen two or more resistors are connected in series, the resistor with the lowest resistance will operate at the highest power. If the power developed by a resistor exceeds its rated power, then the resistor may burn out.
No. The resistance in a series circuit is all the resistor values added together. eg. If two resistors were in a circuit, one was 10 ohms and the other was 30 ohms, the resistance in the circuit would be 30 ohms. Hope this helps!