The emitter
In a Unijunction Transistor (UJT), the arrow mark in the emitter symbol indicates the direction of conventional current flow when the device is forward-biased. The emitter (E) is the terminal where current flows out, and its arrow points toward the base region, which is the junction where the UJT operates. This configuration helps identify the emitter as the terminal that controls the device's operation, distinguishing it from the base and preventing confusion in circuit diagrams.
Depending on context, it could be an infra-red emitter. An emitter that emits at a wavelength longer than that of visible red. infra red emitter is a special pn juction device in which emitter region emits infrared rays
The emitter resistor in a common emitter configuration provides negative feedback to the transistor, reducing both its voltage gain and distortion.
Emitter
The emitter
In a Unijunction Transistor (UJT), the arrow mark in the emitter symbol indicates the direction of conventional current flow when the device is forward-biased. The emitter (E) is the terminal where current flows out, and its arrow points toward the base region, which is the junction where the UJT operates. This configuration helps identify the emitter as the terminal that controls the device's operation, distinguishing it from the base and preventing confusion in circuit diagrams.
it indicates the direction of flow of emitter current
arrows are shown for conventional current, not electron current.
The symbols in the unijunction transistor show its internal configuration. The emitter (arrow) represents the polarity. When it points in that is a P type transistor. Pointing out is an N type. The the table on its side the table top touching the emitter (arrow). Its' "legs" are the connection to two bases in the device. It does not have a collector. Refer to another Wiki answer for more info.
A bench mark is shown as an upward pointing arrow with a bar above the point.
The transistor has three regions, emitter,base and collector. The base is much thinner than the emitter while the collector is wider than both. However for the sake of convenience the emitter and collector are usually shown to be of equal size. The transistor has two pn junctions that means it is like two diodes. The junction between emitter and base may be called emitter-base diode or simply the emitter diode.The junction between base and collector may be called collector-base diode or simply collector diode. The emitter diode is always forward biased and the collector diode is always reverse biased.
Forces are typically shown as vectors in physics, with an arrow representing the direction of the force and the length of the arrow indicating the magnitude of the force. This helps to visually represent how forces act on objects in a particular direction.
A: When a signal is not amplified but simply taken from an emitter the reason is that the emitter will provide better current capabilities
With a common emitter amplifier it's the emitter that is usually grounded.
The symbol that shows direction with an arrow towards North with the letter 'N' (for North) is called a north arrow. It is mostly shown in a cruciform (in the form of a cross)
Depending on context, it could be an infra-red emitter. An emitter that emits at a wavelength longer than that of visible red. infra red emitter is a special pn juction device in which emitter region emits infrared rays