Crank the generator excitation up to 480 or down to 460. For calculations I used 480 volts. A 60kW generator at 480 volts will put out, kW x 1000/1.73 x E x (pf(.9)) = 80 amps. It looks like the machine that is to be run off the generator is a dual voltage machine. Not knowing the HP of the machine wire it to the 460 volt connection. The inrush current might be a problem if the HP is high.
Generator coils generate the voltage, motor coils use the generated voltage.
Into units of what?
Just use 2 of the wires instead of 3.
Rephrase your question so that it makes sense.
Its a servo.
Generator coils generate the voltage, motor coils use the generated voltage.
pls telme 3phase 7.5kwe enerater pric 10 hp g
The terminology for the type of connections you describe is, three phase four wire. These changes are made in the generators junction box. In this junction box you will find a series of taps that can be re configured to change the many voltages that the generator can produce.
No! It doesn't matter if you use two legs or three. The output is 5000 watts
Which starter is best for 7.5 hp 3phase motor?Read more: Which_starter_is_best_for_7.5_hp_3phase_motor
120 degrees
To run a 3phase separator in 1440 depends on the fluid type and the flowing conditions. It is then controlled by pressure and the fluid levels that in the vessel.
Into units of what?
the three phase dc motor never seen yet motor eaither 3phase m/r or dc motor.
60.4
1400rpm
B 1U $ x2 x2