Yes it can work on ac source but u will need a different design keeping in mind about the polarity.
No, the two systems need a different coil resistance.
AC source of electric power changes changes polarity constantly, in amplitude.
Technically YES. But the source of power in Electric cars being DC through batteries, the motor must be DC and not AC.
we will get rectified voltage at the output.in case we replaced the DC source with AC source
DC Motor works on DC source and AC motor works on AC source
Is it a doorbell? What do you need the bell for? The type of bell determines what source of electricity is used. Once you determine the type of bell it is, you can hook it up to the right circuit. I had to install a doorbell that worked off the AC current. I also installed one that contained a battery. When you say electric bell, you need to clarify what type of bell it is so a more accurate answer can be given, especially if the answer I provided above it not accurate for you. Thanks for your question.
No, the two systems need a different coil resistance.
A variable speed module in a motor can work with ac or dc source
AC source of electric power changes changes polarity constantly, in amplitude.
Technically YES. But the source of power in Electric cars being DC through batteries, the motor must be DC and not AC.
we will get rectified voltage at the output.in case we replaced the DC source with AC source
Some use AC electric power from a wall outlet. Some use DC electric power from a rechargeable battery (but this was originally charged using AC electric power from a wall outlet).
DC Motor works on DC source and AC motor works on AC source
A transformer in an AC unit works by converting the voltage of the electricity from the power source to a level that is suitable for the unit to operate. This allows the AC unit to function properly and efficiently.
train uses acpower as its source.as in case of dc there would be only steady state conditions and transmission distance would be low.but in ac,it is sinusoidal waveform and transmission of power source can be done at a larger rate with high effeciency and minimal lose.so ac source is used in electric trains.
Thomas Edison did not invent the electric chair; he was against its use. However, he did work on developing direct current (DC) electricity to compete with alternating current (AC) systems, which were used in the first electric chairs. Edison saw the electric chair as a way to discredit AC technology, which was promoted by his rival, George Westinghouse.
To convert ac electric power into mechanical power.