It rose from the ground to protect girls on top of it from a bear, who scratched its sides
create a sentence for contour line
A contour line is a line defining elevation on a map.
The word contour does not exactly have an antonym, however, it you use contoured, the antonym would be flat.
- Contour lines never cross. All lines on a contour line represent one elevation.- The spacing of contour lines depends on slope characteristics. Contour lines that are close together show a steep slope. Contour lines that are far apart show a gentle slope.- Contour lines that cross a valley or a stream are V shaped. The C points toward the area of the highest elevation. If a stream or river flows through the valley, the V points upstream.-The tops of the hills, mountains, and depressions are shown by closed circles. Depressions are marked with short, straight lines inside the circle that point down slope to the depression.
Contour.
. It rose from the ground to protect girls on top of it from a bear, who scratched its sides
when is the elevation rises.
Terrace farming cuts flat platforms in the side of the mountain. Contour uses the curves of the mountain to plant the crops. Both are used to reduce erosion.
The road followed the contour line around the mountain. The contour line was smooth and created good air flow over the wing.
It depends how steep the mountain or hill is, usually the contour lines are bolded and is every fifth line. hope this helped
the height of the mountain
contour lines that are very close together
the top of the elevated hill, slope, or mountain.
According to the ( 1998 ) Ford Contour Owner Guide : ( it is 179.4 inches in length )
Hill,Slope or Mountain
Mountains are represented as triangles on map
First of all, you need to make the mountain without the contour lines with the sandbox tools,Then, move the whole mountain above the ground say, 6". Then, make a huge rectangle quite a bit bigger then your mountain, then make the rectangle a component, copy it up about 1-50' (Making an array) depending on the size of your mountain until you can't see the top of the highest peak, and select the mountain and all of the rect components, and run Intersect With Model. Then, delete the components, and move the mountain, and the newly created contour lines, back to their original spots. Done!