Highway Addressable Remote Transducer Protocol
You give it back to the owner, who has the manual.
In this situation, to calibrate a transmitter you need a power circuit and communicator circuit. The Hart communicator used in the calibration process is connected to the power source circuit in parallel. The power source circuit is the one that has ammeter, 250 Ohm resistor, and power source all connected in series. As the transmitter sends output mA, it creates volt drop across the 250 Ohm resister. Let's say the volt drop across the resistor was 1 Volt. Now, back to the Hart communicator. It is a load, meaning there will be a volt drop across the Hart communicator. Since it is in parallel with the power circuit, it is also parallel with the resistor. So, the 1 volt drop across the 250 Ohm resistor will also make 1 volt drop across the Hart communicator. Technically speaking, the 1 volt drop across the Hart communicator is only true if its resistor is also 250 Ohm. However, it does NOT matter what voltage drop is in the Hart communcator. It only sees the "relative" voltage drop changes to measure the changes in transmitter outputs.
Bret the hit man Hart
The Cisco IP Communicator is a desktop application that allows your computer to be turned into a Cisco IP phone with a full range of features. You can then place and receive calls.
Nokia Communicator
A salesman must be an excellent communicator. If a salesman is not a good communicator they will not sell anything.
there I am Joe Hart and My family are called the Hart family Thanks x
The Communicator - IPFW - was created in 1969.
netflix.
Revation Communicator was created in 2003-11.
A successful message is when the communicator has passed on the message and the reciver gives responsive feedback and has full understanding of the message transfered.
The full name gives it away. Its called the Hart's tongue fern. See the related link for more information.