crank shaft sensor take off and clean it is on the bell housing ofthe gear box
Put the card in, press the brake or clutch and press start
Well, honey, if you're looking for the crankshaft sensor on a Renault Scenic 1.6, you better roll up your sleeves and get ready to dive under the car. It's usually located near the crankshaft pulley, which is down there by the engine. So grab a flashlight and start crawling - it's not gonna jump out and introduce itself to you!
Could be a bad fuel pump, clogged fuel filter or something in the electrical system is getting overheated like a coil or crankshaft sensor.
From what I can tell, the rattle is most likely coming from your alternator, Take It In!
To diagnose and fix the no-spark issue in your 2003 Renault Megane Scenic, start by checking the ignition system components, including the spark plugs, ignition coils, and the ignition module. Inspect the wiring for any damage or corrosion. Additionally, check the crankshaft position sensor, as a faulty sensor can prevent spark generation. If these components are functioning properly, consider using an OBD-II scanner to identify any trouble codes that may indicate further issues.
Had same problem on mine, took the TDC (Top Dead Centre) sensor off, cleaned it and has been fine since. there are some good photos on how to do this if you google it. Good luck Rich
did u bump start it? it may not be your card it could be your starter motor or even immobiliser, try a jump start first your starter maybe burnt out
To remove seats from a Renault Scenic, start by sliding the seat forward to access the rear bolts. Use a socket wrench to remove the bolts securing the seat to the floor. Once the bolts are removed, tilt the seat backward and disconnect any electrical connectors if applicable. Finally, lift the seat out of the vehicle carefully.
Had the same problem. The immobilizer light just stop blinking. Couldn't start the vehicle. Key re-coded. Problem solved
No
if its Scenic 2 - just pull back the break (left to steering wheel (for European cars)) and it should show you on display that break is on. start driving and it will release itself! if its Scenic 2 - just pull back the break (left to steering wheel (for European cars)) and it should show you on display that break is on. start driving and it will release itself!