0
What else can I help you with?
Peugeot 206 glx what is the yellow light on the dashboard that looks like a gearbox it is always on?
That is ECU fault warning light, take it for diagnostics to find the exact fault
Why won't parking lights got out on peugeot 206?
ECU defekt.
Where can i locate the fuel pump relay on a peugeot 206 hdi?
under the ecu
Where is the airbag ecu on a Peugeot 206?
remove the centre console and its under there, around the handbrake
How do you reset the ecu in a Peugeot 207?
207 will not start 1.4 hdi above radio it says ecu fault
Where is the automatic choke on a Peugeot 206?
to my knowledge the 206's are all fuel injected, so the cold start is controlled by the engine ECU.
Airbag ecu on Peugeot 206?
What about it? If you want to know where it is, remove the centre console from around the handbrake and its under there.
Error code ecu in a peugeot 206?
for ecu reset must disconnect cable battery for 45min and reconnect battery cable and start the engine
Can you change the airbag ecu on a 206?
Yes, you can change the airbag ECU on a Peugeot 206, but it's important to follow proper procedures. First, ensure that the battery is disconnected to avoid accidental deployment of the airbags. After replacing the ECU, you will need to reset the airbag system using a diagnostic tool to clear any fault codes and ensure the system functions correctly. Always consult the vehicle's service manual for specific instructions and safety precautions.
How do you remove the ecu from a peugeot 206 located under fuse box?
To remove the ECU from a Peugeot 206 located under the fuse box, first disconnect the vehicle's battery to ensure safety. Then, carefully remove the fuse box cover and any securing clips or bolts to access the ECU. Disconnect the wiring harness and any connectors attached to the ECU, and finally, remove any screws or bolts holding the ECU in place before gently extracting it from its location. Make sure to handle the ECU with care to avoid damage.
How do you reset the ecu in a Peugeot 206?
disconnect the battery for 45mins, with the doors closed. After 45mins reconnect the battery and open the drivers door and you should hear a beep. your ecu will be reset. then take it out for a drive trying to keep to around 2000-2500rpm for the ecu to calibrate to the parameters.
Where is the ECU on a Peugeot 307CC?
In the boot
