Put the card in, press the brake or clutch and press start
From what I can tell, the rattle is most likely coming from your alternator, Take It In!
crank shaft sensor take off and clean it is on the bell housing ofthe gear box
did u bump start it? it may not be your card it could be your starter motor or even immobiliser, try a jump start first your starter maybe burnt out
put the key card in put it in first keep your clutch down pick up some speed and let clutch out quick giving it some revs
To diagnose and fix the no-spark issue in your 2003 Renault Megane Scenic, start by checking the ignition system components, including the spark plugs, ignition coils, and the ignition module. Inspect the wiring for any damage or corrosion. Additionally, check the crankshaft position sensor, as a faulty sensor can prevent spark generation. If these components are functioning properly, consider using an OBD-II scanner to identify any trouble codes that may indicate further issues.
To remove seats from a Renault Scenic, start by sliding the seat forward to access the rear bolts. Use a socket wrench to remove the bolts securing the seat to the floor. Once the bolts are removed, tilt the seat backward and disconnect any electrical connectors if applicable. Finally, lift the seat out of the vehicle carefully.
Had the same problem. The immobilizer light just stop blinking. Couldn't start the vehicle. Key re-coded. Problem solved
if its Scenic 2 - just pull back the break (left to steering wheel (for European cars)) and it should show you on display that break is on. start driving and it will release itself! if its Scenic 2 - just pull back the break (left to steering wheel (for European cars)) and it should show you on display that break is on. start driving and it will release itself!
To bleed the clutch on a Renault Megane 1.6 16v, start by locating the clutch slave cylinder, typically found on the transmission. Use a wrench to open the bleed valve, then have an assistant press the clutch pedal several times before holding it down. While they hold the pedal, close the bleed valve to prevent air from entering. Repeat this process until you see a steady stream of fluid without bubbles, ensuring the clutch system is free of air.
Well, honey, if you're looking for the crankshaft sensor on a Renault Scenic 1.6, you better roll up your sleeves and get ready to dive under the car. It's usually located near the crankshaft pulley, which is down there by the engine. So grab a flashlight and start crawling - it's not gonna jump out and introduce itself to you!
Not sure if this works the same way as the Megane, but here goes. Put your key card in the ignition slot and press start. Do not press the clutch or brake. Press and hold in the button at the end of the light stalk for about 5 seconds, or untill it bleeps twice. This should re activate the auto lights. Well at least it worked for me