http://search.express.ebay.com/items/Mercedes-Benz-manual_W0QQ_nkwZmercedesQ20benzQ20manualQQtrZQQruZ
Here is a picture of the engine and it shows most of the routing
hope this helps someone.
I had to do a little creative problem solving to find it!
Belt routing is on a decal in the engine compartment. Some are also in the owner's manual.
There is usually a diagram under the hood on the fan shroud or the header panel around the radiator.
hi i have uploaded the diagram to the following address just click download at the bottom of the page http://savefile.com/files/1571939
I found that when you buy a new belt you can ask the person at the parts counter to print a copy of the routing diagram for you. (advanced autoparts)
Try this: http://forums.justcommodores.com.au/attachments/vt-vx-holden-commodore-1997-2002/44176d1200653873-diagram-required-routing-serpentine-belt-drive-belts.jpg
The drivebelt routing decal on the radiator shroud to help during drivebelt install
There is a picture in the motor compartment.
I had to replace my belt and was forced to use a different route to put my belt on instead of the one pictured in the sticker that should be on the hood. You can email me and will send you a picture of what the diagram is and show you what I had to do. alcharles@excite.com
royal pain in the ass, look at your diagram under the hood for routing, i bought a serpentine tool, it has shallow sockets included, since theres no room on the idler.
Yes, I need a diagram of the serpentine belt for a 1997 3.8 liter Bonneville SE without a turbo charger.
MORE INFORMATION NEEDEDWhat type of engine do you have? Number of cylinders, and Liters? 1998 ford e 150 van 8 cylinder 4.6lneed to find out the serpentine belt configuration
To change the serpentine belt on a 1997 Oldsmobile Aurora, first, locate the belt routing diagram, usually found on a sticker in the engine bay or in the owner's manual. Use a wrench or a serpentine belt tool to relieve tension on the tensioner pulley, then carefully slide the old belt off the pulleys. Install the new belt according to the routing diagram, ensuring it is seated properly on each pulley, and finally, release the tensioner to secure the new belt in place. Double-check the belt alignment and operation before closing the hood.