0
What else can I help you with?
What are the cylinder head torque settings for a fiat punto 1.1 55?
Fiat do not issue torque settings for a punto they use angles so that you can snap your stretch bolts! after contacting fiat and haynes neither of them would give proper torque settings, so i delved into my many tech manuals on fiat fire engines which is what is in your punto and i have successfully changed many fiat punto head gaskets using the following torque settings: stage 1 starting from the centre head bolts tighten to 33nm: stage 2:65nm and finally stage 3: 96nm these torque settings work fine and will probably save you buying new head bolts.
What are the cylinder head torque settings for a fiat punto 55s?
Fiat do not issue torque settings for a punto they use angles so that you can snap your stretch bolts! after contacting fiat and haynes neither of them would give proper torque settings, so i delved into my many tech manuals on fiat fire engines which is what is in your punto and i have successfully changed many fiat punto head gaskets using the following torque settings: stage 1 starting from the centre head bolts tighten to 33nm: stage 2:65nm and finally stage 3: 96nm these torque settings work fine and will probably save you buying new head bolts.
What are the cylinder head torque settings for fiat uno 1100 fire?
The cylinder head torque settings for the Fiat Uno 1100 Fire engine typically are around 20 Nm (15 lb-ft) for the initial stage, followed by a final torque of about 70 Nm (51 lb-ft) in a specific sequence to ensure even pressure distribution. It's essential to consult the vehicle's service manual for the exact specifications and sequence, as variations can occur based on manufacturing changes. Always use a calibrated torque wrench for accurate settings.
What are the main bearing torque settings fiat 1100?
Oh, dude, you're asking me about torque settings for a Fiat 1100? That's like asking a sloth to run a marathon. I mean, who even cares about that stuff? Just tighten it until it feels right, or, you know, consult the car manual if you're feeling adventurous.
What are the torque settings for the Fiat panda Cylinder Head?
There isn't a specific torque for the little 8v fire engine..and the head bolts need to be initially tightened to 30Nm and then a further 90 degrees twice over..remember also to use new bolts because the old ones will have stretched..
Are there any particular problems to be aware of or is it just a straight forward job to change the head gasket on a 1997 Fiat Punto SX 60 automaic?
i asume you know your spanners so yes it is a straight forward job. and to help you on your way the torque settings are Fiat Punto Fire engine Stage 1 30Nm/22LBf ft Stage 2 59Nm/43.5LBf ft
Where can you find a wiring diagram for a Fiat Uno Fire?
I need a copy of the wiring diagram for a fiat mia
A car beginning the letter F?
* Fire Bird * Fiat
Where is the engine number of a fiat uno fire engine?
The engine number of a Fiat Uno Fire engine is typically located on the engine block itself. It is usually stamped onto a machined flat surface on the engine block for easy identification. You may need to visually inspect the engine block or refer to the vehicle's owner's manual for the specific location of the engine number on a Fiat Uno Fire engine.
What are the settings in shivas fire?
Suzanne Fisher Staples' Shiva's Fire is set in Madras, India.
1992 cavalier injectors not getting signal and no fire to plugs?
Check the camshaft sensor. If the sensor is bad or not getting power, then the engine will not fire and the injector will not get a signal.
What is the lug torque spec for a 2001 sun- fire?
100 Ft. lbs
