To fit a rear seat belt in a Citroën Xsara Picasso, start by locating the anchor points on the vehicle's chassis. Ensure the seat belt is threaded through the correct guides, following the path indicated on the belt itself. Securely attach the belt's buckle to the latch, ensuring it clicks into place. Finally, check the belt's retraction mechanism to ensure it functions properly before use.
Take the old one out, and put the new one in
Psi 36 for C4 Grand Picasso, front and rear.
how do i change rear brake pads on 53 plate Picasso hdi
Look underneath the rear of the car.
clipped to lid in rear underfloor storage compartment
It tips forward. remove headrest, and release to sprung catches at rear of seat, it then will tip forward
Access is from inside of vehicle under boot carpet below offside rear passenger seat.
it is located under the passenger seat. The seat tilts forward like the rear seats however the catches are very difficult to release.
Take out spanner from the right hand rear floor compartment. Unscrew the bolt attaching the wheel from the inside of the boot.
if is xsara picasso then: from inside move carpet on the left side, there you see two metal parts which need to be squeeze and all rear light come off. Then you take off plastic where are all bulbs in, brake, direction and reverse bulb
To change the rear washer nozzle on a Citroën Picasso, first, locate the nozzle at the rear of the vehicle, usually on the tailgate. Use a flat-head screwdriver to gently pry off the old nozzle from its housing. Connect the new nozzle to the washer hose and push it firmly into place. Finally, test the new nozzle by activating the rear washer to ensure proper operation.
it is a the rear of the air intake...right at the back /top of engine..you have little room to take out two srews ....it will have a plug lead going to it. this is on a 1.6